How to Put a Belt on a Kenmore Heavy Duty Dryer
Kenmore heavy duty automatic dryers are typically higher capacity than standard Kenmore dryers. They are designed to withstand more frequent use than a typical residential appliance. Some parts, such as the drive belt, may wear out quickly under heavy use. A broken or worn-out belt prevents the motor from effectively rotating the drum. Replace the damaged belt to restore your Kenmore heavy duty dryer to proper working order. Does this Spark an idea?
Instructions
-
-
1
Disconnect the power cord from the electrical socket to prevent the chance of shock.
-
2
Pull the lint filter out of the filter compartment on the top of the unit. Remove the two screws located next to the filter compartment.
-
-
3
Slide the putty knife into the gap under the top panel in the front of the dryer. Slide the knife along the gap to locate the internal clips on the right and left corners. Press the knife into the clips to unhook them.
-
4
Lift the top panel up and rest it on the wall behind the dryer.
-
5
Remove the screws located near the top of the front panel. Unplug the wire connector leading into the door switch. Lift the front panel out of the cabinet base and set aside.
-
6
Position the wood block under the drum to stabilize it. Move the idler pulley away from the drum to loosen the belt. Slide the old belt off of the drum and motor pulley.
-
7
Position the new belt around the drum. Position the other end around the pulley. Move the idler pulley back into its original position to restore belt tension.
-
8
Remove the wood block from under the drum. Replace the front panel onto the Kenmore dryer cabinet. Plug the door switch connector back into its socket. Install the screws on the top of the front panel.
-
9
Lower the top panel back onto its original position on the Kenmore heavy duty dryer. Press down on the panel to snap the internal clips closed. Replace the two screws next to the lint filter compartment.
-
1
