Johns Manville produces a number of insulation products, including roll and bat fiberglass insulation that is fastened to a either a Kraft paper or foil front. The facing adds a vapor barrier to the insulation product not found in friction-fit insulation or blown-in insulation. Installation of the foil-faced insulation follows the same processes as other insulation projects and falls within the abilities of do-it-yourselfers with average carpentry skills and equipment.
Things You'll Need
- Tape measure
- Straight board
- Sharp utility knife
- Staple gun with 1/2-inch staples
Roll out the insulation with the foil face down on a unfinished floor or plywood base. Measure the length of insulation needed with a tape measure and place a straight board across the insulation at that point. Press the insulation down with the straight board and cut along the edge of the board with a sharp utility knife. Cut through the foil face of the insulation and into the unfinished floor or plywood.
Place the cut piece of insulation into the wall cavity. The foil face should be toward the living area of the home. The insulation should fit by friction between the studs. The insulation must reach all the corners of the wall space. Do not compress or stretch the fiberglass insulation while installing. Either process changes the insulation's effectiveness.
Fold the foil or paper flanges over the wall studs. Staple in place with 1/2-inch staples. The friction should hold the insulation in place; the staples only hold the facing in place to increase its effectiveness as a vapor barrier.
Tips & Warnings
- Wear a breathing mask while working with fiberglass insulation.
- Cut the packaging material on the sides rather than across the roll to avoid cutting the foil insulation face.
How to Insulate a Bathroom Fan Vent Pipe
Bathroom exhaust fans exhaust air out of your bathroom through a duct that is connected to the fan and runs out your...
How to Paint Foil Faced Insulation
If you want to paint foil-faced insulation, you must first employ the proper preparation techniques. The foil facing on insulation is nonporous,...
How to Install Solar Board Insulation
Solar board insulation acts as a radiant barrier that reflects heat energy from the sun. Solar board can either consist of a...
Foil-Backed Fiberglass Insulation Installation
Foil-backed insulation products have gained popularity as homeowners experiment with passive solar techniques and the nation emphasizes energy conservation. Radiant barriers are...