How to Make Your Own Cheap Hydroponic Set-ups


Not all gardens require large outdoor plots. Hydroponic gardens allow you to grow small crops of vegetables and herbs inside your home. Purchasing a hydroponic kit can be rather expensive, especially if you just want to grow a few plants as a fun hobby. Putting together your own hydroponic set-up can save you some money, especially if you recycle a used aquarium.

Things You'll Need

  • Aquarium
  • Plumber's caulk
  • Measuring tape
  • Styrofoam sheeting
  • Serrated knife
  • 4 or 5 plastic plant pots
  • Perlite
  • Paper towels
  • Seeds
  • Sphagnum moss
  • Grow light
  • Aquarium airstone
  • Hydroponic mix
  • Fill your aquarium with water to check for leaks. Patch any leaks with a waterproof plumber’s caulk. Let the caulking dry for the recommended amount of time. Rinse the surfaces of your aquarium to remove any soil or debris.

  • Measure the opening in the top of your aquarium. Transfer these measurements to a piece of 2-inch thick-Styrofoam sheeting, tracing the shape of the opening. Cut out the Styrofoam sheeting with a serrated knife, making your cuts slightly inside the lines, so your piece of Styrofoam is a little smaller than the opening of your aquarium.

  • Place your plastic pots upside-down on the top of your cut piece of Styrofoam. Spread the pots out to leave about 3 inches between each one. Trace the outline of the pots on your Styrofoam. Remove the pots and cut out your shapes with your serrated knife, again cutting just inside your lines.

  • Press the bottoms of the pots into your piece of Styrofoam until the rims are almost even with the upper surface of the Styrofoam sheeting. Fill your pots with perlite. Set a small piece of clean paper toweling over the perlite in each pot. This biodegradable surface helps to hold your small seeds in place while they germinate and form roots. Lay four or five seeds on top of the paper towels. Cover your seeds with a fine layer of sphagnum moss to provide the necessary darkness for sprouting.

  • Set your aquarium in its permanent location, placing it under a grow light. Place the airstone in the center of your aquarium.

  • Mix your hydroponic solution according to the package instructions. Fill your aquarium with your solution. Plug in your airstone and adjust the setting to provide a thin trickle of gentle bubbles. Place your Styrofoam sheeting and pots over the surface of the liquid solution, submersing the suspended pots into the hydroponic liquid.

Related Searches


  • Photo Credit Jupiterimages/Comstock/Getty Images
Promoted By Zergnet


You May Also Like

  • How to Grow Strawberries

    Growing strawberries (Fragaria × ananassa) requires some care, but the freshly picked, sweet, juicy fruits are worth the effort. Strawberries grow as...

  • How to Build a Micro Hydropower Plant

    Hydroelectric power (hydropower) is a largely untapped source of energy that you can harness without producing harmful emissions. The Earth's atmosphere acts...

  • How to Make a Cheap Hydroponics System

    One of the cheapest and easiest hydroponics systems employs gravity to transport the water to and from your growing container. It is...

  • How to Make Cheap Room Dividers

    You're sick of work-sleep-living in one cramped studio space. Making your bed is a daily travail, but staring at the rumpled comforter...

  • How to Make Your Own Hydroponic Nutrient Solution

    Hydroponic gardening involves growing plants in a combination of nutrient-rich solution and a root-securing matrix other than soil. One benefit of hydroponic...

  • How to Build Cheap Hydroponics

    Building your own hydroponic system is a very affordable way to control and grow your own herbs, flowers, or vegetables. This do-it-yourself...

  • How to Make Your Own Hydroponics Net Pots

    Growing plants indoors with a hydroponics system does not have to be an expensive investment. You can make your own plant net...

Related Searches

Check It Out

4 Credit Myths That Are Absolutely False

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!