Keeping the fuel lines in working order on your car or vehicle is important. A leaking fuel line can expose gasoline or diesel to a hot engine part, which can then ignite the fuel. Fuel lines need to be kept in good repair to avoid such a potential risk to safety and your car. Unfortunately, some of the parts involved are not easy to repair -- such as an air filter. Leaks can also develop in a variety of locations, so you have to look at both the fuel lines and their fittings for problems.
Things You'll Need
- Wheel ramps
- Drip pan
- New rubber fuel line
- New pre-shaped hard tube fuel line
- Tube bender tool
- New fuel line fittings or banjo clamps
- Socket wrench and sockets
- Crescent wrench
Put on mechanic gloves and goggles before getting started with the mechanical work. Place a drip pan under the area where you are working to catch any fuel that escapes when you open up a line. Place your car up higher on wheel ramps so you can get accessibility underneath the car engine.
Use a screwdriver or socket wrench and appropriate socket to release fuel line fittings that you find while working on a leaking line. Open the line up on one end and drain any remaining fuel out before disconnecting the other end.
Use a flat-tip screwdriver to lever off a stubborn fuel line if it is stuck. Pull the line off its spigot. Examine the fuel line once it is removed. Look for cracks, holes, or splits in the rubber line. Look for friction spots where the line may have been pinched and worn down.
Examine the fittings for the fuel line to see if they have been damaged enough to leak fuel between the threads. Replace the old fittings with new ones and measure the distance needed for a new fuel line. Purchase a sufficient amount of new rubber fuel line and install it on the fittings. Purchase a pre-shaped tube and associated fittings if the fuel line section is a hard tube type. Use a tube bender tool to get the angle correct when installing on the engine. Tighten the fittings with a socket or crescent wrench.
Clean up any remaining areas around the engine that you worked on and lower the car off the wheel ramps. Prime the engine by pumping the throttle pedal and start the engine so that it draw new fuel through the line. Let it run for a bit. Turn it off and look underneath the engine again for any signs of remaining leakage.
Tips & Warnings
- It helps to use two crescent wrenches when tightening a new fitting. This keeps the connection in place while tightening a new fitting on. Do not overtighten as it will stretch the fitting which will cause a new leak.
- If you're not sure about your mechanical abilities, you should let a certified mechanic perform this kind of work.
- Photo Credit pumping gas image by Mat Hayward from Fotolia.com
How to Repair a Fuel Line in a Car
Fuel lines develop leaks when part of the line rubs against anything metal under the vehicle. Typically the frame rail is responsible...
How to Find a Fuel Leak
Take precautions to prevent risks to your health and home when looking for a fuel leak. Do not smoke while you perform...
How to Fix a Gas Tank Leak in a Car
If you smell gas when you're in or around your car, chances are you have a gas leak. If upon visual inspection...
How to Patch a Fuel Line
The fuel line of your car supplies gas from the fuel tank to the carburetor, making the combustion necessary for the engine...
How to Repair a Rubber Fuel Line
Repairing a rubber fuel line requires the right tools, supplies and knowledge. When a leak is found in the rubber fuel line,...
How to Stop a Fuel Leak
If there is a presence of a gas smell around your vehicle, there may be a fuel leak. After you complete a...
How to Fix a Gas Line Behind the Stove
In order to fix a gas line behind a stove, you need to have either a loose fitting or loose connection. Fix...