Old plaster walls may be generally solid and in good shape, but still too cracked, wavy and uneven to hang wallpaper or other wall coverings on. One solution is to thin coat the wall. This is the process of spreading three very thin layers of joint compound (a form of plaster) over the whole wall, from top to bottom, so it fills the depressions and evens everything out. It's a messy, dusty job, so seal off the room from the rest of the house before you start.
Things You'll Need
- Paint scraper
- Joint compound
- Drywall tape
- 4-inch drywall knife
- 12-inch drywall knife
- Drywall sanding pad
- Sealing primer with rollers
Scrape the wall thoroughly of all loose paint, dirt, crumbling plaster and anything else that might interfere with the adhesion of the thin coat, using a paint scraper.
Repair any deep cracks or holes by spreading on some joint compound with a 4-inch knife, pressing a piece of drywall tape over it, then spreading more compound over the tape. Get the compound smooth and flat. Let it dry for three or four hours.
Spread the first coat of thin coat over the wall starting at the top and working down with your 12-inch drywall knife. Work in horizontal courses, pulling the knife across the wall at a shallow angle, making the plaster thin enough that you can see through it on the flat spans of the wall. It should fill any small cracks and depressions. Do the whole wall.
Let the compound dry about four hours. Scrape over it with your 12-inch knife to knock off any ridges or peaks.
Lay on the second coat in the same manner as the first, starting at the top and working across and down. Again, keep it very thin, almost transparent, so it fills the depressions without piling on the wall.
Let the second coat dry for four hours. Scrape it, and add the third coat in the same manner.
Let the third coat set for eight hours. Sand it lightly, by hand, just enough to take off any lines or ridges and smooth it all out. Coat the wall with sealing primer.
Tips & Warnings
- Wear a dust mask when sanding.
How to Prepare Walls for Painting Skim Coat
When you skim coat a wall, you apply a thin layer of drywall joint compound to the entire wall in order to...
How to Repair Effervescing Plaster Walls
Effervescing, or bubbling plaster walls, can occur from water damage and typically exist in bathrooms where humidity and moisture are most prevalent....
Problems With Skim Coating Plaster Walls
Skim coating is the process of applying thinned joint compound to a wall and then smoothing it out. Plaster walls were once...