How to Use the Sanitize Feature on the Frigidaire Dishwasher


The sanitize feature on newer models of Frigidaire dishwashers ensures the cleanliness of your dishes by heating the water for the final rinse cycle to 155 degrees Fahrenheit for nine minutes. You will find the "Sanitize" button pad in the line of pads along the top front of the machine. The water heater that provides hot water to the dishwasher should be set at 120 degrees. Any interruptions, such as a power failure, will interrupt the heating process, resulting in your dishes not being sanitized.

  • Load the dishwasher with dirty dishes. Add the detergent and any rinse aid you use. Latch the door and select the cycle you want to use. You can only use the sanitize feature on the "Pots and Pans," "Normal Wash" or "Econo Wash" cycles. "Econo Wash" is for lightly used dishes.

  • Press the "Sanitize" pad. A light will come on above the pad.

  • Turn on the faucet in a sink near the dishwasher and let it run until the water is hot. Turn off the water and press "Start" to run the dishwasher.

Tips & Warnings

  • Before using the "Sanitize" feature, ensure that your water heater is set at 120 degrees Fahrenheit.

Related Searches


  • "Frigidaire Dishwasher Use & Care Manual"; Electrolux Home Products Inc.; 2002
  • Photo Credit Jupiterimages/ Images
Promoted By Zergnet


You May Also Like

  • How to Sanitize Dishwashers

    Your dishwasher may do a good job removing the food particles and debris from your dishes. However, are you certain your dishwasher...

  • Bosch Dishwasher Operating Instructions

    Bosch dishwashers automatically wash and sanitize your dishes, allowing you to keep your kitchen clean with less effort. The under-the-counter design allows...

  • Frigidaire Washer Instructions

    Frigidaire's line of front-loading washers offer multiple cycles and wash options that allow you to adjust the spin speed, temperature and soil...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!