How to Program Spektrum DX7 Radios

Save

The Spektrum DX7 radio is designed to work with radio-controlled model aircraft. This radio will help you navigate your way to safety either before or after you leave the ground. You can store up to 20 different airplane or helicopter models in this radio. It can also be programmed to work in trainer mode. This will help navigate your flight prior to leaving the ground. The Spektrum DX7 radio can help you make an automatic landing while in-flight. Take along the Spektrum DX7 radio for a safe flight.

Storing a Model

  • Turn the Spektrum DX7 radio off by holding down the "Power" button.

  • Press the "Down" and "Select" buttons at the same time then turn on the "Power" switch. This will open the "System Setup Mode."

  • Press either the "Increase" or "Decrease" keys until you see "Model Select" on the screen.

  • Press either the "Increase" or "Decrease" keys to select the model of the airplane or helicopter you want to store in the memory. Press "Select" when done. The Spektrum DX7 comes preloaded with information about different model airplanes and helicopters. Once you select a particular model, it will call up information about the particular aircraft.

Trainer Mode

  • Hold the "Down" and "Select" keys at the same time while turning on the transmitter.

  • Press the "Up" key until you see the word "Transfer" on the display screen.

  • Press either the "Increase" or "Decrease" keys to select what type of training you want to do. "Normal" is the most basic training mode. In "P-Link," the master transmitter maintains control of all secondary functions, including gear flaps, dual rate and expo while the primary stick controls everything else (elevator, rudder and throttle). In "SLAVE/P-Link" mode, the transmitter works with the radio as the master programmer.

  • Other People Are Reading

  • Press "Select" when done to enter training mode.

Automatic Landing

  • Turn the device on by holding the "Power" button.

  • Press the "Select" key until the you see the word "Auto" highlighted.

  • Press either the "Increase" or "Decrease" buttons to activate the "Automatic Landing System."

  • Change the value by pressing either the "Increase" or "Decrease" keys (0% means low stick while 100% means full stick).

  • Clear the auto land point by pressing the "Clear" button. The display will return to the "INH" screen.

References

  • Photo Credit airplane image by Melissa Schalke from Fotolia.com
Promoted By Zergnet

Comments

You May Also Like

  • What Does DX Mean in Radio?

    Heinrich Hertz discovered radio waves in 1887, and since then the radio has become a common item. Sometimes people pick up non-local...

  • How to Bind Dx7

    The Spektrum DX7 is a spectrum radio system for RC aircraft. It has the DSM2 technology, which allows large gas and glow...

  • How to Program a 6 Channel RC Transmitter

    Only the most complex radio-controlled vehicles require a 6-channel transmitter to function properly. For the most part, these transmitters are used by...

Related Searches

Check It Out

Geek Vs Geek: Robot battles, hoverboard drag race, and more

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!