Remodeling your bathroom can increase the value of your home and make living in it more comfortable. Removing a bathroom wall may be part of the project; just make sure it is not a load-bearing wall or exterior bearing wall. Removing a load-bearing wall needs to be done by a professional. Removing a non-load bearing bathroom wall is a project easily done in one afternoon.
Things You'll Need
- Plastic sheeting
- Duct tape
- Eye mask
- Face mask
- Hard hat
- Steel-toe shoes or work boots
- Utility knife
Check with a professional before you tear down your bathroom wall to make sure it is not a load-bearing or support wall. If you remove a load-bearing wall your house could collapse. You can also examine the original blueprints of the house.
Determine which wall you want to remove in your bathroom. Estimate where the electrical outlets, ductwork and plumbing are within the wall. When you tear down the wall there could be hidden electrical and plumbing, so be careful during the demolition.
Turn off the electricity to the bathroom so if you come into contact with any electrical wiring, there won't be any electrical shocks. Turn the water off to any of the plumbing that may be in the wall.
Duct tape plastic sheeting behind the wall you will be removing. Cover the entryway to the room with plastic sheeting as well. This will seal off the rest of the house from the dust and debris that will float in the air with the demolition. Cover the floors with drop cloths. Put on protective eyewear, gloves, steel-toed shoes, hard hat and a face mask.
Remove the electrical outlet covers. Double check to make sure the electricity is turned off by testing the light or electrical outlet. Use a crowbar to remove the baseboards and molding from around the floor or ceiling. Use a utility knife to slice through the paint and drywall tape at the top of the wall that meets with the ceiling. Breaking through this will ensure you don’t rip into the ceiling during the demolition.
Remove any tiles covering the wall by hammering into one and then prying off the rest. Punch a hole through your drywall with a hammer. Pry the rest of the drywall off the studs with your hands.
Take out any metal outlet boxes, brackets or braces. Pull the electrical wiring up and cap the wires or re-route them to a different location. Cap the plumbing to prevent water leakage when you turn the water back on.
Saw off the studs close to the floor stud or knock them out with a heavy hammer. Saw the studs up near the ceiling and remove them. Pry off the 2 by 4 that is on the floor with a crowbar, as well as the one at the ceiling if there is one. The floor and ceiling should be flush now; if it is not, remove any boards or nails that are left.
- Photo Credit bathroom image by Mikhail Olykainen from Fotolia.com
How to Replace a Fiberglass Shower
Many people replace their shower stalls either because it's out of style or the configuration no longer suits their requirements and a...
How to Remove a Bathroom Sink
You can learn how to easily remove your counter top or wall- mounted bathroom sink and save the money you would spend...
How to Remove Brown Spots from Bathroom Walls
Brown spots that show up on bathroom walls or ceilings after showers and baths are mold or mildew caused by condensation. If...
How to Remove Bathroom Caulking
The purpose of caulk in the bathroom is to prevent water from getting into crevices. Moldy, old or decaying caulk does not...
How to Remove Bathroom Wall Paneling
Removing bathroom wall paneling can be easy or difficult. Much depends on the kind of adhesive used on the paneling and how...
How to Tear Down a Wall
Remodeling can be as simple as painting the walls, or involve more complicated projects such as tearing down a wall. When doing...
How to Tear Down a Block Wall
A block wall is built one block at a time and it can be torn down the same way. The blocks are...
Mold & Mites in the Walls Behind Electrical Outlets
Mold and mites are two nuisances that can cause homeowners headaches. Mold is a type of plant fungus that can decay walls,...