The Ford pickups have several different engine options available but since moving to the serpentine belt system, they have used the same type of tensioner and basic system design on their engine. The system uses a spring-loaded serpentine belt tensioner that moves with the belt as the belt wears and stretches. This keeps the belt adjusted at all times but even with the movement, the belt will eventually stretch beyond the limits of the tensioner and require replacing.
Things You'll Need
- Wrench set
- 3/8-inch drive ratchet
- Pencil and paper (optional)
Locate the negative (black) battery cable on the battery of your truck. Remove the retaining bolt from the battery terminal with a wrench, then remove the cable.
There should be a belt-routing diagram in the engine compartment of the truck. If there isn't, or if the diagram is illegible, draw a diagram of the belt's routing on the various pulleys on a piece of paper, for later reference.
Locate the serpentine belt tensioner on the front of the engine near the passenger's side of the engine. There is a square hole in the end of the arm to insert the square drive from a 3/8-inch-drive ratchet into.
Rotate the serpentine belt tensioner counterclockwise with a ratchet to loosen the belt. Remove the belt from the pulleys then carefully rotate the tensioner back clockwise. Discard the old belt.
Install a new belt around the pulleys except the tensioner, following the diagram exactly. Rotate the tensioner counterclockwise, slide the belt onto the pulley and rotate the tensioner clockwise to tighten the belt. Check that the belt is centered on all the pulleys.
Install the negative battery cable onto the negative battery terminal and tighten the retaining bolt with a wrench. No other adjustment of the belt is required.
Tips & Warnings
- On some Ford truck engines, you will need to remove the fan and fan shroud.
- "Ford F Series Truck Factory Service Manual"; Ford Motor Company; 1996
Cost to Replace a Serpentine Belt
The cost of replacing a serpentine belt in a vehicle depends on whether you plan to replace the belt yourself or whether...
How to Replace Serpentine Belt on a Ford F150
Replacing the serpentine belt on a Ford F150 requires loosening the belt tensioner. However, depending on your particular model, you may have...
How to Change a Serpentine Belt on a F250 Ford
The 3/4-ton F250 Ford pickup truck is the next step up from the half-ton F150. Utilizing a heavier frame, suspension and drive...
How to Change a Fan Belt on a Ford E-150 4.6
Replacing the fan belt or serpentine belt on a Ford E-150 4.6L is a somewhat challenging yet rewarding job. The serpentine belt...
Ford 300 6-Cylinder Timing Specs
The Ford 300 is an in-line, six-cylinder engine. The small-block engine was released by Ford in 1965 on the F series pickup...