The blower motor in your 1995 Jeep Cherokee is located inside the heater duct work from the engine compartment side. The blower is moves both air through the heater core to warm it or the air conditioning evaporator core to cool it then through the air ducts and into the passenger’s compartment of your Jeep. If you blower has stopped working completely, changing it is the best option. If it is still working on at least one speed, check the ballast resistor before replacing the blower motor.
Things You'll Need
- Wrench set
- Socket set
- Small pry bar
Open the hood of your Jeep and locate the negative battery cable. Remove the retaining bolt from the cable end with a wrench or socket and ratchet then remove the negative cable from the battery, isolating it from the terminals while you are working to prevent accidental contact.
Locate the coolant overflow bottle on the firewall just above the blower motor. Remove the retaining strap by unhooking the clip from the front of the support bracket and lift the bottle off the tray. Remove the three mounting bolts from the tray with a socket and ratchet, then remove the tray.
Locate the blower motor on the passenger’s side firewall. Remove the electrical connector from the terminals on the outer edge of the blower motor housing and set the wiring harness aside. Do not pull on the wires when you remove the harness or you will damage them.
Remove the mounting bolts on the face of the blower motor with a socket and ratchet. Carefully pry the blower motor loose from the housing with a small pry bar. Slide the blower motor out of the housing, the fan or cage will still be attached so you will have to work that out of the hole in the housing as well.
- "1995 Jeep Cherokee Factory Service Manual"; The Chrysler Group.; 1995
What Does a Blower Motor Resistor Do?
"Blower motor" refers to an electrically operated fan in a vehicle that supplies air to the passenger compartment. The heater blower resistor...
How to Replace a 1995 Jeep Cherokee Ignition Switch
Jeep Cherokee models have been popular for several decades in the United States, making spare parts widely available for do-it-yourselfers to try...
How to Replace the Window Motor on a 2003 Jeep Grand Cherokee
The power motor inside the door is responsible for raising and lowering the window in your Jeep Cherokee. Many times, these motors...
How to Test a Jeep Grand Cherokee Blower Motor Control Module
The Jeep Grand Cherokee has an ongoing problem with the harness connector-to-blower motor control module overheating and melting. This causes either intermittent...
How to Change the Blower Motor in a 1992 Jeep
The blower motor circulates the heat given off by the heater core throughout the cabin of your Jeep when it&rsquo;s turned on....
How to Replace the Heater Core on a 2002 Jeep Grand Cherokee
If the windshield on your Jeep Grand Cherokee won&#039;t properly defrost or the passenger side of the vehicle has a wet floor...
How to Change the Heater Fan Motor in a Jeep Cherokee
Flushing your Jeep Cherokees' cooling system every year to keep it from clogging up is a good idea. However, if your heater...
How to Replace the Blower Motor Resistor on a 1998 Jeep Cherokee
The blower motor on your 1998 Jeep Cherokee is powered by a resistor that essentially acts in the same capacity that a...