Working with sheet metal trim is a skill that takes practice. Cutting and bending metal to cover window and door frames when siding your home also takes the proper tools. One of the most important tools you will use is the metal roller. A roller holds the roll of metal so that you can pull out how much you need, measure it and cut it with out having to deal with a long, unrolled strip of trim. These tools can cost quite a bit, but, with a few materials you can make your own metal roller and get on with the job.
Things You'll Need
- Plywood (30 inches by 10 inches by 1/2 inch)
- Tape measure
- Speed square
- Drill with 3/8 inch bi-metal bit
- 2 all thread rods (1/4 inch by 8 inches)
- 4 washers (1/4 inch inside diameter)
- 4 nuts (1/4 inch inside diameter)
- 2 adjustable wrenches
- Roll of sheet metal in the box
- Flat iron bar (2 inches by 30 inches)
- 2 wing nuts
- Work gloves
- Safety glasses
Measure across one end of the plywood, from either side, with your tape measure. Make a mark on the wood with your pencil at 15 inches. Place your speed square onto the end of the plywood, line it up with your mark, and make a V mark with the bottom of the V pointing at the 1 inch mark on the square. Repeat at the opposite end. Drill through the plywood at the point of both V marks.
Twist a nut onto one end of a rod so that the end of the rod is flush with the edge of the nut. Flip the rod over, slide on a washer, and slip the all thread through one of the holes in the plywood. Slide a washer onto the top of the rod and twist on a nut to secure the rod to the plywood. Grasp both nuts with a wrench and twist to lock the rod firmly to the plywood. Repeat with the other rod.
Measure and mark the flat bar at a point in the center of the bar 1 inch from each end. Drill through the metal bar at both marks.
Rip open the cardboard box and pull the roll of metal free. Hold the roll firmly to prevent it from unrolling when the binding is released. Locate the ends of the binding, flip the plastic and pull the long end to release the binding from the roll.
Lay the roll of metal between the rods on your roller. Slide the flat bar through the open middle of the roll of sheet metal. Slip the holes in the bar over the all thread rods and push it down to the bottom so that it holds the roll in place. Twist a wing nut onto each threaded rod. Do not over tighten the wing nuts as that will bind the sheet metal and prevent you from pulling it out for work.
Pull the end of the sheet metal so that it comes out of your roller face down. Pull out only as much as you need for the job at hand, plus 12 inches. Roll the sheet metal back onto the roller and twist the wing nuts down tightly to secure the roller and left over metal for transport.
- Photo Credit aviation tin snips image by Christopher Dodge from Fotolia.com
How to Build a Model Roller Coaster
Building a model roller coaster is a great, hands-on way to learn about physics and centrifugal force. Whether you plan to build...
How to Build Low Budget Sheet Metal Hand Brakes
A sheet metal brake is a very handy tool for metal workers, but is not found in many home hobbyist shops. Small...
How to Make a Concrete Lawn Roller
Landscape maintenance is a chore, no way around it. Keeping a beautifully manicured lawn takes a lot of work and the right...
How to Use a Sheet Metal Bead Roller
A sheet metal bead roller is used to add rigidity to sheet metal and is often used in the HVAC industry for...