How to Operate a Chrysler Stow-N-Go
Chrysler's Stow-N-Go seating system folds the second and third-row seating into the floorboard, which can give the van the appearance of a cargo vehicle. Once you get the hang of it, operating the Stow-N-Go system is straightforward. If your Chrysler van with Stow-N-Go has a power-operated third-row seat, please see the Tips section.
Other People Are Reading
Instructions
-
Second-Row Seats
-
1
Move both front seats all the way forward, and then remove any items from the floorboard in the second row seating area.
-
2
Push the second-row headrests toward the front of the cabin to fold them down. Raise the armrests to the "Up" position, in-line with the seat bolsters.
-
-
3
Move the floorboard storage panel lever (in front of the second-row seats) to "Lock." Pull up on the plastic handle to open the storage panel.
-
4
Pull the side-seat lever up to fold the seatback onto the cushion (both sides). Locate the nylon strap behind the second-row seat; pull the strap out to release the rear part of the seat from the floorboard; push the entire seat toward the front of the cabin to fold it into the floorboard. Close the storage panel. Repeat the process for both second-row seats.
Third-Row Seats
-
5
Open the rear liftgate. Push the headrests down, toward the front of the cabin. Firmly pull the nylon strap labeled "1." This will fold the seatback onto the cushion.
-
6
Pull the nylon strap labeled "2" to release the rear seat anchors.
-
7
Pull the nylon strap labeled "3" to lower the seat into the storage compartment (the rear seat folds rearward--unlike the front seat, which folds forward).
-
1
Tips & Warnings
If your Chrysler has power operated third-row seating, open the rear liftgate, press and hold "Stow" until the seat is stowed.
To raise the seats back to their normal position, follow the each step in reverse.
