How to Fix a Hole in a Galvanized Tin Roof

Save

To create a long-lasting watertight repair on a galvanized tin roof, you need to use galvanized metal and a sealant that does not break down when exposed to ultraviolet (UV) light. This eliminates caulk and silicone sealants, as both break down when exposed to heat and UV rays. When the sealant fails, water will penetrate the hole repair, allowing rust to form under the roof repair. When rust forms, it will extend the size of the hole that you have fixed in the galvanized tin roof.

Things You'll Need

  • Ladder
  • Galvanized sheet metal 4-inches larger than the hole
  • Roll of butyl gasket
  • Sharp knife
  • 5/16-inch hex head adapter
  • Variable speed drill motor
  • #10 self-tapping sheet metal screws
  • Set up the ladder to allow you safe access to the section of roof that has the hole.

  • Unroll a 12-inch length of butyl gasket from the roll, and place the end of the butyl gasket on the sheet metal with the outer edge of the butyl tape even with the side of the galvanized metal patch.

  • Press the gasket onto the metal patch as you continue to work the butyl gasket around the perimeter of the patch. When you reach a corner on the metal patch, tear the backing paper of the butyl gasket to allow you to turn the corner easier.

  • Cut the butyl gasket with the sharp knife when you reach the point that you started placing the butyl gasket on the metal patch.

  • Secure the 5/16-inch hex head adapter into the chuck of the variable speed drill motor.

  • Climb the ladder, center the metal patch over the hole in the galvanized tin roof and lay the metal patch onto the surface of the galvanized tin roof.

  • Press firmly around the perimeter of the metal patch to work the gasket onto the surface of the tin roof.

  • Place the head of a #10 self-tapping sheet metal screw into the 5/16-inch hex head adapter you placed in the chuck of the variable speed drill motor.

  • Run a screw approximately 1-inch in from the corner of the metal patch. Continue running screws through the metal patch and into the galvanized tin roof, while keeping the screws roughly 2 inches apart.

  • Remove all material from the surface of the galvanized metal roof before you climb down the ladder.

Tips & Warnings

  • Do not climb onto a galvanized metal roof when it is wet from rain or condensation.

Related Searches

References

  • Photo Credit Jupiterimages/Photos.com/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • How to Repair Nail Holes on a Wall

    Interior redesign often means picture and furniture rearranging which calls for repairing nail holes left behind from prior picture hanging. Nail hole...

  • How to Repair a Galvanized Metal Roof

    Although galvanized metal roofing has an average life expectancy of 50 years, weather and objects can cause the metal roof to leak....

  • How to Fix Nail Holes in a Roof

    Finding roof leaks can be difficult because the source of the leak and where the water is actually dripping may be in...

  • How to Repair Nail Holes in a Metal Roof

    Repairing nail holes in a metal roof is an inexpensive alternative to replacing portions of the roof. Repairing holes in a roof...

  • How to Repair a Tin Roof

    Popular in the late 1800s and early 1900s, tin roofs are still installed on homes. Tin roofs are environmentally friendly, extremely wind-resistant,...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!