How to Replace an Old House's Intercom System

Save

As households become less reliant on a hard-wired phone system and more dependent on cellular phones, a wireless home intercom system makes sense. If you don't require landline phones, why integrate your in-home communications with that redundant technology? A five-channel wireless intercom system can provide communication with five units and one or two doorbell units.

Things You'll Need

  • Drill
  • Screwdriver
  • Pencil
  • 9-Volt battery
  • Prepare the first console and antenna. Pull the antenna out from the bottom of the case and point it straight up.

  • Locate your five consoles. The kitchen is the obvious first location. Children's bedrooms, a den and the garage could be good locations. Plug the consoles into a nearby power source.

  • Mount the doorbell units. Insert a fresh battery into the units. Use the mounting plate and pencil to mark the screw locations. Try to keep the units out of direct weather. Attach the mounting plate to the wall with the screws. Tilt the doorbell unit into the mounting plate and secure it with the locking screw underneath. Don't tighten it yet.

  • Wall mount or simply place the other consoles on a table. To wall mount the console, route the power supply behind the unit. Use the template that came in the instruction manual and mark the mounting screw locations on the wall. Drive the screws in leaving about 1/4 inch exposed. Mount the consoles on the screws. They just slide on.

  • Switch the consoles on and test the system. Press the doorbell button and all the consoles should chime. You will need a buddy to help you with this. Respond to the doorbell caller by pressing and holding the Talk button on the console. Adjust the volume on the doorbell as necessary. The adjustment is on the back. When you've got it right, tighten up the locking screw.

  • Test console-to-console calling. Press a console button and then press and hold the Talk button. Wait for the beep and speak. One of the receiving consoles station indicators will light up to show which station called and sound the message. Respond by pressing and holding the Talk button.

  • Label the station indicator lights and buttons with the location of the consoles.

  • Remove the old redundant equipment and discard.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Install an Intercom System

    Although wireless intercom systems are easier to install, if you are building your home a wired intercom system still has many advantages....

  • How to Wire an Intercom

    Although wireless intercoms are becoming more popular, many people still prefer to wire their intercom system. By wiring your system you will...

  • How to Remove Old Intercom Systems

    Hardwired intercom systems are being outdated with the latest innovations in the intercom industry. Wireless technology has also been adapted by modern...

  • How to Make a Homemade Intercom

    Intercoms serve a variety of purposes and are commonly found in schools and large companies. Their primary functions are to allow communication...

  • How to Repair Intercoms

    If you have an intercom system that isn't working as it should, it can be frustrating as it will mean you may...

  • How to Reset an M&S MC602 Intercom

    The MC602 is an intercom device created by M&S. An intercom is used to allow wireless communication between people in different areas....

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!