How to Extend a Toggle Clasp Bracelet

Save

It is always frustrating when you discover your favorite bracelet is a bit too small. Often this piece will end up in a box for years waiting for someone to fix it; however, with just a few supplies, you can extend a toggle clasp bracelet yourself, allowing you to use it again.

Things You'll Need

  • Jump rings
  • 2 pairs jewelry pliers or regular needle nose pliers
  • Electrical tape
  • Sewing-style measuring tape

Simple Steps for Extending Your Bracelet

  • Purchase the correct type of jump ring. Jump rings are wire rings used for attaching jewelry components. They can be soldered or open. Use open jump rings for this project. Find jump rings that match the metal of your toggle clasp. Look for jump rings between three mm and six mm for the extension. You can find jump rings at almost any jewelry or craft supply store.

  • Measure your wrist, and then measure your bracelet to figure out how much longer you need it to be. Remember the toggle has to be pushed through the ring of the clasp to fasten it, so measure at least an extra centimeter for ease of use. Examine how the clasp is attached to your bracelet. If built properly, the clasp should be attached via a jump ring. Figure out how much length you need to add to the bracelet and divide that length in half.

  • Open the jump rings holding the clasp by grasping each side of the opening with your pliers and carefully pulling one side of the ring toward you and pushing the other side away in a twisting motion. Create the smallest opening possible to avoid weakening the metal. If you have jewelry pliers, the inside of the nose will be smooth so it won't scratch metal. If you have to use regular pliers, wrap the ends with electrical tape to keep the teeth from damaging your jump rings. Remove both sides of the toggle clasp.

  • Figure out how many jump rings you need on each side of the bracelet to reach the correct length. Create a chain of jump rings by attaching them to each other. Attach your new jump rings in equal number on each side of your bracelet until you have reached your desired length. Fasten each side of the toggle clasp to the ends of your jump ring chains. When you close your jump rings, use minimal force to keep from crushing the rings.

Tips & Warnings

  • If your bracelet is not professionally made, it may be attached directly to the toggle clasp without any jump rings. In this case you will need to restring the bracelet with jump rings to lengthen it.

References

Promoted By Zergnet

Comments

You May Also Like

  • What Is a Slave Bracelet?

    The term "slave bracelet" conjures visions of exotic Middle Eastern belly-dancing slave girls and Celtic knotted jewelry. No one seems to know...

  • How to Lengthen Your Stride

    A longer running stride gives you more power with each step and, for some, can translate into faster speeds. Stride length is...

  • How to Attach a Toggle Clasp to a Bracelet

    Toggle clasps come in a wide variety of shapes, sizes and metals. Adding personality to handmade and store-bought bracelets, the clasp is...

Related Searches

Check It Out

This Is the Beauty Routine of an Ex-Pat in China

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!