×
Back Button

How to Cut Fiberglass Corrugated Roofing Panels

C.L. Rease

Fiberglass corrugated roofing panels allow diffused light to enter a structure while providing a strong but lightweight covering for your outbuilding. The corrugation of the panels provides increased strength over flat sheets.

Corrugated fiberglass roofing panels resist corrosion better than metal panels.

Cutting fiberglass roofing panels require tools capable of cutting at higher speeds without cracking or splintering the edges of the panels. Both hand and power saws used to cut wood will cut through a fiberglass roofing panel with the correct blade and with the proper amount of pressure.

Tip

Save the cut off piece of panel to mark other panels needing to be cut.

Warning

Wear safety glasses when using a circular saw.

  1. Set a length of fiberglass corrugated panel on a stable worktable.

  2. Pull a tape measure along the panel and place a mark on the panel with a pencil where you need to cut it. Place enough marks to make a reference line across the panel.

  3. Hold the fiberglass roofing panel loosely with one hand to keep it stable during the cut.

  4. Align the plywood blade of a circular saw with a pencil mark located near one edge of the panel. Pull the trigger of the saw to start it. Push the saw slowly toward the edge of the panel to start the cut. Push the saw at a steady pace across the panel. Allow the panel to bounce while you cut to avoid cracking the fiberglass.

  5. Increase the speed you are pushing the circular saw when you near the end of the cut. Set the cut piece aside.

  6. Pull a utility knife along the cut edge to remove the cutting burr from the fiberglass roof panel.

The Drip Cap

  • Fiberglass corrugated roofing panels allow diffused light to enter a structure while providing a strong but lightweight covering for your outbuilding.
  • Cutting fiberglass roofing panels require tools capable of cutting at higher speeds without cracking or splintering the edges of the panels.
  • Place enough marks to make a reference line across the panel.
  • Pull a utility knife along the cut edge to remove the cutting burr from the fiberglass roof panel.