How to Build a Wood Lattice Patio Cover

Save

Many decks are raised, leaving a large space underneath that all kinds of creatures can crawl under. In order to seal it off, you need to build some sort of preventative shield to keep things out from under. The cheapest way to do that is to use wood lattice.

Things You'll Need

  • Sheets of lattice Hammer Nails Saw Tape measure Shovel
  • Measure the outer sides of the deck. Sheets of wood lattice come cheapest in 4-by-8 feet measurements. Determine how many sheets you will need by totaling up the square footage. A 4-by-8 sheet measures 32 square feet.

  • Dig a 2-inch trench around your deck. This will allow the lattice a tight fit once you've installed it.

  • Cover the longest open stretches (without turns) of the deck first. Drop the sheets of lattice in the trench, and cut them off at the deck-line. When you've reached a good fit, put two or three nails into the sheet of lattice to secure it in place.

  • Repeat until the deck is complete. Use the saw to cut your sheet around any grooves or poles that might be in the way. Use the scraps you've cut from the large sheets in the smaller, tighter areas if you can.

  • Once completed, push dirt back into the trenches to secure the lattice in place.

Related Searches

Promoted By Zergnet

Comments

You May Also Like

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!