How to Replace the Filter on the GE Under-sink Filtration
Water filtration systems by GE come in a wide range of models, including under-sink reverse osmosis systems. The under-sink units use replaceable filters that keep debris and large particles out of the water. A clogged filter can reduce water flow and impair the filtration system's ability to clean the water properly. Does this Spark an idea?
Instructions
-
-
1
Turn off the water supply line leading to the filtration system.
-
2
Turn on the GE filtration system water faucet to drain the tank. Turn off the faucet when the tank is empty.
-
-
3
Twist the filter compartment to the left to disconnect it.
-
4
Empty the water from the compartment. Pull the old filter out of the filter compartment.
-
5
Insert the new filter into the cartridge.
-
6
Position the filter compartment onto the filtration system. Twist the compartment to the right. The cartridge moves up as it is tightened.
-
7
Turn the water supply leading to the system on. The tank takes up to four hours to refill.
-
1
References
- "GE Reverse Osmosis Filtration System Owner's Manual"; General Electric; 2010
