Removing Dents From Finished Wood

A dent in a wood surface detracts from the beauty of finished wood and necessitates repair. Raising the dent from a wood surface will restore the beauty and leave the surface without a trace of damage.

1. Fill the wood dent with a few drops of plain hot water from an eyedropper. If the surface is not flat, skip to Step 2.



2. Place thick, dry rags around the perimeter of the dent to protect undented wood from the repair process.



3. Wet a clean rag and wring out excess water. Place the damp rag over the dent.



4. Turn a clothes iron on to the highest heat setting and allow the iron to warm up fully.



5. Place the clothes iron onto the damp rag and allow the heat of the iron to create steam. Move the iron back and forth over the dent. Keep the iron over the dent only. Do not allow the iron to come in direct contact with the wood surface.



6. Remove the iron and lift the rag. If the dent remains, wet the rag again and repeat the process. The steam created by the water in the wet rag and the heat of the iron will cause the wood fibers to swell, thereby raising the dent flush with the existing surface.

Tip

Do not allow the iron to remain on the rags for a long period of time because it can cause the fabric to catch fire, igniting the wood surface. Wet the rag each time it dries to create more steam.