Car Instrument Panel Problems


The electronic sophistication of modern cars extends to the dashboard. Electronic instrument clusters display such critical data as speed, mileage, fuel level and malfunction warnings. A faulty instrument cluster may display inaccurate or nonsensical readings, or it may not operate at all. The error may stem from a voltage problem, or from incorrect grounding or a bad sensor. These complex panels usually require total replacement instead of simple repairs.

Electrical Problems

  • A faulty instrument cluster or wiring harness can blow a fuse, causing the instruments to go dead. If the replaced fuse blows immediately, then one of these two components probably has a short in it. Tracing the wiring circuit with a voltmeter can reveal the failure point in the electrical system, while checking the wiring harness with an ohmmeter can determine whether the power circuit has a good ground connection.

Electronic Problems

  • Electronic gauges depend on the accuracy of computerized sensors to feed them accurate data. notes that if an isolated indicator misbehaves, the problem may lie with the individual sensor for that indicator. If indicators fail to light up and multiple gauges malfunction, then the issue probably lies in the instrument cluster itself.

Problem Identification

  • points out that some cars run self-checks on their instrument clusters during ignition. During this self-check, all the indicators should light up, and any indicators that fail to come on may indicate an instrument cluster problem. Some cars make it possible to request a self-check by selecting certain display buttons.


  • According to, most car manufacturers view the instrument cluster as a single component, so if even one indicator fails the repair shop must replace the entire unit. Although dashboard lights may prove replaceable by car owners, many of these lights now come built into the circuit board of the integrated instrument cluster.


  • recommends disconnecting the car battery before attempting any kind of electrical system repairs. A connected battery could cause a short, leading to a fire, or cause the airbag system to deploy. Additionally, the Federal Truth in Mileage Act requires that in cars with an electronic odometer, the installer must either transfer the memory chip from the original instrument cluster or reset the new instrument cluster so that the car will display an accurate mileage reading.

Related Searches


  • Photo Credit Image by, courtesy of andrewarchy
Promoted By Zergnet


You May Also Like

  • Problems With Chevy TrailBlazers

    The TrailBlazer was a mid-size SUV produced by American automaker General Motors through its Chevrolet division. The TrailBlazer was produced between 2002...

  • What Does an Instrument Control Panel for Cars Do?

    An instrument control panel, or instrument cluster, on a vehicle contains information and warning lamps that provide useful information about the relative...

  • How to Replace an Instrument Cluster

    The instrument (gauge) cluster is your guide to the car engine's internal operations; if it goes out, you'll be basically "driving blind."...

  • How to Check Your Dash Lights

    If any of your dashboard lights aren't working, you may be driving around with a problem and not know it - until...

  • Ford E350 Speedometer Malfunction

    The Ford E350 chassis is used in a number of large vehicles, including vans, motor homes and trucks. Speedometer problems in these...

  • Parts of an Instrument Panel

    An instrument panel, also referred to as a dashboard, is the surface below the windshield of a vehicle that provides the driver...

  • Removing Instrument Cluster From Dash

    Tips for removing speedometer and odometer. Learn the proper service procedure for installing dashboard lights in a 1996 Ford Explorer in this...

Related Searches

Check It Out

How To Travel For Free With Reward Points

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!