Our candy slider is nearing completion. The next thing, I'm going to do is, with my slot punch. Just look about for the center, in the front of the card, here and punch. And then, I can do, two things here. I can just, push it down and eye ball it. And go ahead and punch again. Or I can take my pencil and put a mark there. Either way, as long as you're lined up. And your punch goes through. And mine, just got stuck. That's o.k. I know exactly where to punch. I'm going to just turn it over. Sometimes that happens, when you're punching many layers. And that is, one of the reasons, I like to mark it. Because it's easy, if you have to turn it over, where to look. Alright, now this is the front of my slider. So I want the front of my candy bar, going in the front. Go ahead and push it down. I'm going to take my ribbon, thread it through. Turn it over, take my ribbon, thread it through. And you want to make sure that your ribbon is lying flat. And you can check this, when you go to test it. And just make sure that both sides, that your ribbon is lying flat. And how easy, that slides. So now, I'm going to just pull them both together. Tie a big knot. I've never had anyone, not be able to figure these out. But if you give it to someone, make sure you put, let them know. That they just pull, to get their candy. The next thing, we're going to do, is finish decorating it.