How to Thin Spackling Compound

Save

Spackling compound is a pasty joint or hole sealer that comes ready to use right out of the container or as a powder to which you add water to make a paste. With either form, some of the water may evaporate over time causing the Spackle to become hard, dried-out or too thick or crumbly for proper use. But there's no need to toss it and buy more; you can thin hardened spackling compound. Use Spackle compound, or joint sealer, thinned to the proper consistency for projects such as sealing drywall/sheetrock joins or filling nail holes.

Things You'll Need

  • Warm water
  • Putty knife
  • Wooden spoon or clean paint stir-stick
  • Mix the Spackle with a putty knife to check its texture. It should resemble that of creamy cake frosting. If it's thick or dried-out and looks cracked, stir or break the compound loose with the putty knife creating cuts or seams for water to seep in.

  • Pour a small amount of warm water over the Spackle. For a gallon of Spackle, start with approximately 1/2 cup of water.

  • Work the water into the compound using the putty knife. Use a crisscross cutting motion or stir until the Spackle becomes pliable. Add more water as needed to form a creamy paste.

  • Stir in a circular motion with the wooden spoon or paint mixing stick until you have a lump-free mixture resembling fluffy cake icing for sealing drywall/sheetrock joins or slightly thicker than smooth peanut butter for filling nail holes. Press any lumps against the inside of the container to break them up using the back of the spoon or the stick.

Tips & Warnings

  • Use a power drill with a mixing tool, such as a paint mixer, to mix water into the Spackle compound. Spackle will shrink as it dries if you add too much water when preparing the compound. Apply overly thinned joint compound to "over-flush" and sand to flush when dry. Additional layers may be required.

References

  • Photo Credit Comstock/Comstock/Getty Images
Promoted By Zergnet

Comments

You May Also Like

  • Spackling Compound Vs. Plaster or Drywall Compound for Repairs

    Minor damage to plaster walls can be repaired with spackle or drywall joint compound, but substantial repairs should be made with plaster.

  • How to Clean Spackle

    Spackle is a plastic-like paste used to fill cracks or holes in plaster or drywall. Ceilings are also often spackled to provide...

  • How to Use Spackling Tape

    Doing your own drywall repair around the house is the sort of job that is difficult and frustrating early on. But the...

  • How to Add Water to Spackling Paste

    Spackle is used frequently to patch holes and give drywall an even surface. After spackle paste is applied, it will harden and...

  • How to Add Spackle to Paint

    Spackle, or joint compound, fills the joints between sections of drywall and fills in holes and depressions on the surface of the...

  • How to Repaint Over Chipped Paint

    Painting over chipped paint involves a series of steps, including checking for lead and getting the area smooth.

  • How to Thin Joint Compound

    Joint compound has numerous uses around the house. It is often used to fill in small imperfections on walls or divots caused...

  • How to Put Spackle on Ceilings

    Spackle is a type of adhesive repair compound. Spreading spackle over small holes, nail heads, cracks, seams and gaps conceals the imperfections....

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!