How to Sew an Arched Window Treatment

Save

Many window treatments do not take too much time or effort to make. However, if you have an arched window that needs some kind of a treatment, you may just be staring at it not knowing what to do. Marking an arched window treatment takes planning. Do not let an arched window get the best of you. You can make a lovely window treatment following a few simple tips.

Things You'll Need

  • Arched window treatment rod
  • Measuring tape
  • Fabric
  • Pins
  • Install your arched window treatment rod. Hold the rod up to the window casing and decide on its placement. There is not standard for hanging arched curtain rods, so you have control. Attach the hardware to one side of the window casing.

  • Take some careful measurements both vertically and horizontally for the hardware you installed on one side. Transfer those measurements to the other side of the window casing and install the hardware for the other side.

  • Install any supports that may be needed at the center section of the window treatment rod.

  • Determine how much fabric you need by measuring the width of the window and doubling it. Measure the length of the window from the highest point in the arch and add 10 inches.

  • Form a hem on the sides of the window treatment by folding the fabric over 5/8 inch. Stitch with a sewing machine to hold the hems in place.

  • Create a rod pocket at the top of the window treatment. Fold down the top edge of the fabric to the back of the curtain 3 inches. Fold under just the raw edge and sew in place. Sew another seam 1 ½ inches higher.

  • Determine the appropriate length for your curtains by hanging them in the window. Trim them 2 inches longer than you want the finished edge.

  • Remove the curtains from the window and the curtain rod. Fold under the bottom edge of the window treatment 1 inch and then another 1 inch using pins to hold the fabric. Sew to form the hem.

Tips & Warnings

  • Always allow a little extra fabric when sewing curtains to fit in any arched window or doorway. This allows you extra length to make sure that the window treatments will be long enough.
  • If you want your window completely covered, you can form the bottom of your window treatment into a sunburst. However, you will need an extra piece of rod for this. Look for special sunburst-style rods.

Related Searches

References

  • Photo Credit Photos.com/Photos.com/Getty Images
Promoted By Zergnet

Comments

Resources

You May Also Like

  • How to Make a Sunburst Sheer Curtain

    Decorative round half windows and doors with half-circle windows above the lintel are attractive additions to a house but pose a decorating...

  • How to Hang Curtains in Arched Windows

    Arched windows can be a problem if you're trying to cover them with a window treatment. The arch usually adds a lot...

  • DIY Arch Window Coverings

    Arch windows are designed to be architectural accents to a room. Sometimes, though, an arch window allows too much sunlight into the...

  • Ideas for Arched Window Treatments

    Arched windows are nothing short of a beautiful sight. However, many homeowners are perplexed as to the proper way to dress their...

  • Round Top Window Treatments

    Round top windows, also known as Palladian or arched top windows, add architectural interest to a home, but they present a challenge...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!