How to Remove Oil From Paver Stones

Save

Whether your car leaked automotive oil on your concrete paver driveway or you've spilled cooking oil from the grill on your brick patio, the best way to remove the oil is to absorb it with some type of absorbent powder and then scrub the area with a detergent or degreaser. Act as quickly as possible to clean the spill since the porous surface of both bricks and pavers will pull the oil down into the material. You'll need to pull the oil back out of the stones and then clean away any dirt that was carried into the surface along with the oil.

Things You'll Need

  • Clean rags
  • Absorbent material, such as kitty litter
  • Broom
  • Detergent or degreaser
  • Scrub brush
  • Hot water

Step 1: Wipe It Up

Wipe up the spill with a clean rag, removing as much oil from the surface as you can before it soaks into the pavers. Be sure to absorb the oil with the cloth, but don't rub the stain as this will smear the oil over more of the pavers.

Step 2: Soak It Up

Sprinkle an absorbent material such as cat litter, diatomaceous earth or talc powder over the stained area. Allow the absorbent material to sit on the stain for 24 hours and then sweep it up.

Step 3: Scrub Up

Apply a detergent, degreaser or oil remover to the pavers to remove any remaining dirt or oil. Allow the detergent to soak in for a few minutes and then use a scrub brush to thoroughly clean the area.

Tip

    • Always test detergent and other solvents on a discreet area before using them on your pavers. Some cleaning agents may cause additional staining.
    • Oil-based stains from deck stain may need to be tackled with a store-bought graffiti remover to get rid of the coloration.

Step 4: Rinse It Off

Rinse away the detergent with hot water and allow the pavers to dry. If you can still see the stain when the pavers are dry, apply more detergent and try scrubbing them again. Removing all of the stain may require several attempts.

Tip

    • It may be impossible to completely remove the stain, especially if the oil that spilled onto the pavers was extremely dirty. Pavers that won't come clean can be replaced individually as can stubbornly stained bricks.
    • Once you have the pavers or bricks clean, consider sealing them to prevent future oil accidents from soaking in.

Related Searches

Promoted By Zergnet

Comments

You May Also Like

  • How to Get Oil off Driveway Pavers

    Driveway pavers create elegant and inviting curb appeal for properties. Unfortunately, the pavers can become stained if they are not properly cared...

  • How to Remove Oil From Patio Pavers

    With the wide variety of paver options on the market, you can see why many homeowners are choosing to have this decorative...

  • How to Remove Oil Paint From Stone

    Individually, oil and paint stains on stone both pose difficult cleaning obstacles to overcome. Porous stone readily absorbs and diffuses oil, "darkening"...

  • How to Clean Stains on Pavers

    Paver stones are a more decorative way to pave your patio, walkway or driveway. In addition to offering the aesthetic appeal of...

  • How Can I Remove Stains From Paver Bricks?

    Paver bricks are a simple way to enhance your outdoor décor. Used to create walkways, driveways, patios and exterior floors, paver bricks...

  • How to Remove Stains From Concrete Pavers

    There are many types of stains that develop on concrete pavers. The most common stains are made by oil and grease. Many...

  • Cooking Oil Paving Stain Remover

    A paved walkway, patio or driveway enhances the appearance and value of a home. Despite efforts to keep them looking their best,...

  • How to Remove Paver Stone Stains

    Paver stones used for patios, walkways and driveways require periodic cleaning to keep them looking their best. Address stains as quickly as...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!