Assembly Instructions for a Bench Dog Router Table
The Bench Dog ProMax is the only full-size, cast-iron router table currently on the market; its solid top weighs almost 100 pounds. The table provides 5 square feet of work space and features two integrated tracks, with slots for miter gauges and other accessories. The table is designed to fit either the Bench Dog ProStand or ProCabinet. Assembling the table isn't complicated, but you will need a helper because of the sheer weight of the table.
Other People Are Reading
Things You'll Need
- Bench Dog ProMaxRT router table
- Bench Dog ProStand or ProCabinet
- Router insert plate
- 4 hex head screws, 1/4-20 x 1/2 inch
- 3 split lock washers, 1/4 inch
- 10 plate leveling set screws, 1/4-20 x 1 inch
- 10 hex nuts, 1/4-20
- 1/8 inch hex wrench
- 7/16 inch hex wrench
Instructions
-
-
1
Align the holes in the router table with the holes in the stand or the cabinet brackets.
-
2
Secure the table to the stand or cabinet from below with the hex head screws and split washers.
-
-
3
Install the router insert plate and adjust the leveling set screws until the plate is flush with the top of the router table.
-
4
Hold the leveler with an 1/8-inch hex wrench, tighten the hex nuts with a 7/16-inch hex wrench.
-
1
Tips & Warnings
Once you've installed the router, you may need to adjust the leveling setting on the insert plate to get a good alignment.
The router tabletop is heavy. Get help to lift the top onto the stand or cabinet.
