Constructing a valance box to be placed over a window will bring architectural appeal to any room. A valance box has a top, front and sides, but the bottom is left open to allow window treatments to operate. A valance box made of high-quality wood or beefy moulding can be stained. A plywood box can be painted or covered with fabric. Custom-made valance boxes are typically expensive, but building your own is an inexpensive way to add this high-end custom element to a room.
Things You'll Need
- Measuring tape
- Poster stock
- Electric saw
- Utility knife
- Wood boards, size and type of your preference
- 8 L-brackets
- Wood screws
- Electric drill with 1/4-in drill bit (optional)
- Electric or manual screwdriver
Determine your desired dimensions for the valance box. It should be tall enough to hide any curtain rod, and deep enough to allow blinds or drapes to operate properly underneath it. The width of the box must be at least 4 inches wider than the window, including the window trim, so that the box can be mounted to the wall. Measure the window, including trim, and add 4 inches (2 inches for each side).
Create a pattern for each separate piece of your valance box (top, front, and two sides) by sketching each piece's measurements on your poster stock. The side pieces should have the same measurements. The top and front pieces should be the same length, and the top piece should measure the same depth as the side pieces.
Cut out each pattern piece using your utility knife.
Lay each pattern piece onto a piece of wood. Trace around each piece with a pencil, then use your saw to carefully cut the pieces out of the wood.
Lay the front piece of the valance box flat on a stable surface. Stand one of the side pieces on its edge, placing it on top of the short end of the front piece. Make sure the edges of the boards are aligned, then position an L-bracket where the pieces meet. If desired, use the electric drill and 1/4-inch drill bit to drill a shallow pilot hole through a hole on each side of the bracket and into the wood. Screw a wood screw through a hole in each side of the L bracket. Repeat this step for the opposite side.
Lay your top piece flat on the work surface. Set the three-sided piece on top of it with the short sides facing toward you. Make sure the long edges of the boards meet at the rear and the side edges meet the ends of the top board. Use screws to attach the remaining L-brackets to the wood, as in Step 5. Use one bracket on each side and two to connect the top and front boards.
Sand your valance box and finish it with stain, paint or fabric.
Securely mount your valance box to the wall near the top of the window frame with L-brackets and screws. The top of each L-bracket should extend outward from the wall, parallel to the floor, with the other leg of each bracket sitting flat against the wall. Attach the brackets to the wall with screws, then sit the valance box on top of the brackets. From underneath, screw a wood screw through one of the bracket holes and into the top board of the box. Repeat for the other side.
Tips & Warnings
- Make sure the screws securing the L-brackets to the wall can support the weight of the wood valance box. If there is no wood framing beneath the drywall in the spot where the brackets will be mounted, purchase and install drywall anchors that will hold the valance's weight, and secure the L-brackets to them.
- Photo Credit Photos.com/Photos.com/Getty Images
How to Make a Curtain Box
A curtain box, or window cornice, is a box-like structure mounted along the width of a window frame that enhances its appearance...
How to Make Valance Box
Valance boxes add a decorative element to your decor and hide curtain rods, related hardware and the tops of curtains or draperies....
How to Make Custom Valances for Windows, Box Style
Window treatments are a great way to make them look more finished and give a room an air of elegance. These wooden...