Things You'll Need:
- 5/8 inch melamine coated particle board for a 6 foot by 4 foot by 3 foot freestanding closet
- • Two 3 foot by 6 foot sections for sides
- • Two 4 foot by 6 foot sections for back and front door
- • Two 4 foot by 3 foot sections for top and bottom
- • Two 3 foot by 3 foot shelves
- Two Euro self-closing hidden hinges
- 4 foot rod and attachment assembly
- Shelf brackets
- Sandpaper
- Matching tape to finish raw edges at the front of the carcass and closet edges
- Drill
- Wood screws
- Wood glue
- Four caster feet
- Pull knob (optional)
-
Step 1
Have the lumber company cut all wood to measure. Bring it home and sand to remove any splinters or rough spots.
-
Step 2
Build the carcass by drilling pilot holes where the screws will attach to adjacent pieces. Always put a drop of wood glue into the pilot hole for a better bond. Attach the sides to the back, and then the top and bottom of the closet to the back to form a box.
-
Step 3
Lay the carcass on its back and attach 4 casters, one in each corner, according to package instructions. Use decorative tape to cover raw edges at the front of the closet frame. Place it around the door edges as well.
-
Step 4
Install the Euro hinges on the front inside of the carcass according to instructions on the package. Measure the door and install the other sides of the hinges. Stand the closet up and test the self closing hinges. Adjust as necessary. You may add a decorative pull knob if you wish.
-
Step 5
Install the clothing rod according to package instructions. You may wish to make one rod for pants and skirts and another three feet lower for shirts and jackets. An alternative is to add two shoe shelves at the bottom of the closet. Use brackets to attach the shelves to the back of the closet. Remember to tape the raw edges to give the closet a nice finished look.
