How to Use Old Safety Razors
Because of the economy or personal choice and conviction, many people seek to live more frugally and simply. We are looking back to see how our parents lived. Smaller homes, vegetable gardens, cooking from scratch and homemade entertainment are some frugal choices people are making.
As the price of disposable razors increases, some are starting to question if their convenience is worth the cost, both in terms of our pocketbooks and our landfills. Safety razors are an economical choice for those looking for a close shave but find the idea of using a straight edge or "cut throat" razor a little too daunting.
Does this Spark an idea?
Other People Are Reading
Instructions
-
-
1
Shave after you shower. The heat from your shower will soften the whiskers on your face, making easier to get a close shave and avoid nicks.
If you are not showering, apply a hot damp towel to your beard to soften the whiskers.
-
2
Wet the shaving brush with hot water.
-
-
3
Put a nickle-sized squirt of shaving cream in a mug.
-
4
Swirl the bush in the mug to until the shaving cream forms a thick lather.
-
5
Apply the lather to your face and neck using a circular motion.
-
6
Pull the area you are about to shave taut. The smoother the surface of the skin, the closer your shave. Where you start to shave is a matter of preference and comfort.
-
7
Angle the razor at about 30 degrees away from your face. Using as little pressure as possible, move the razor across the surface of your skin in the direction of the hair growth.
-
8
Make a second pass with the razor before moving to another section of your face.
-
9
Rinse your face with cold water after shaving.
-
10
Apply aftershave. Aftershave lotions help reduce skin irritation from shaving.
-
1
Tips & Warnings
If the hair on your beard is fine and thin, use long strokes. If the hair is coarse, use short strokes. Thoroughly rinse your razor and dry it with a towel after each use. This will prolong the life of your blades and help prevent nicks. Thoroughly rinse your shaving brush, shake out the excess water and allow it to air dry.
