How to Adjust a Ring Size

All Rings must be large enough to fit over the knuckle, but then often tend to be TOO large to sit upright on the finger.

Stones can make a ring top heavy, and they tend to "roll" or "spin" so the stones are not shown properly (often ending up on the palm side of your hand). If your ring is too loose after passing your knuckle this "ring spinning" is even greater. Sometimes spinning right OFF your finger! Ring Guards solve that problem!

Difficulty: Easy

Instructions

Things You'll Need:

• pliers
• a soft cloth
• ring guards from viewithere.com

1. 
   ring adjuster

   Place the ring guard with arms curved upward as shown in the image to the left.

2. 
   put guard on ring

   Place the ring shank inside the curved arm of the ring guard.

3. 
   squeeze guard

   Push down on ring guard so it takes the shape of the shank.

4. 
   attach arms

   With pliers, in a circular motion, tighten the ring guard arm to your ring' s shank. (If you're worried about your ring you may wrap a small soft cloth around the pliers)

5. 
   finished in 30 secs

   Once the ring guard is in place you may adjust the 'size" of the ring. Just push up (or down) on the middle band of the ring guard.

Tips & Warnings

• For Full image by image instructions visit http://viewithere.com/ring_guard/howto.html
• For full video instructions (30 seconds - streaming) visit http://viewithere.com/ring_guard/howto.html
• Order 14K gold filled ring guards at http://viewithere.com/ring_guard
• All images on this page and on viewithere.com are copy right - full and world wide by Viewithere.com

Resources

• BUY RING GUARDS HERE

[toronto]

on 3/13/2009 email [e-mail] tell them you saw this article on eHow and receive FREE shipping