Cleaning a Norelco SensoTouch 3D


The Norelco SensoTouch 3-D is a battery-operated electric shaver with three blades attached to the handheld device to achieve a close shave without skin irritation. It requires regular cleaning to maintain the razor's performance. The SensoTouch 3-D comes with a brush cleaning tool that allows you to remove hair on the surface of the electric razor for quick cleaning, and allows you to rinse off the shaver for deep cleaning clogs in the device. As with any electronic device, the battery or power cable must be removed from the shaver prior to cleaning to ensure safety.

Things You'll Need

  • Norelco cleaning brush
  • Sink

Slide the electric shaver's battery door off of the back of the razor and remove the shaver from the charging station.

Brush off hair and debris from the top of the shaver's head to eliminate loose hair prior to washing the device.

Grab the pull tabs at the top of the shaver head and lift open the razor compartment.

Turn on the sink's hot water faucet and run the razor under the running water for 30 seconds.

Gently shake the shaver to remove excess moisture, and lay the shaver on a hard, flat surface to allow it to thoroughly dry before using it.

Push the razor compartment's door down to shut the compartment and prepare the shaver for use.

Insert the batteries back into the shaver and slide the shaver's door into place, or place the shaver on the charging unit and plug the charging unit's cable into an available power outlet.

Tips & Warnings

  • Brush off loose hair after every use to prevent hair buildup.
  • Wash the razor compartments weekly to keep the razors from clogging.

Related Searches


Promoted By Zergnet


Related Searches

Check It Out

This Is the Beauty Routine of an Ex-Pat in China

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!