DIY Expanded Metal Lath Installation

Save

Whether you’d like a stucco finish on your house or you’ve always fancied a stone façade, installing metal lath is going to be your first step. As with any other finishing job, the first steps are the most important to achieving satisfactory results.

Preparation

Before the metal lath is installed, a moisture-proof barrier must be applied to wood sheathing. This barrier prevents wood decay that would otherwise develop during the application of wet plaster or concrete. Check your local building codes for acceptable types of barrier material and their method of application.

First Steps

After the moisture barrier is in place, install all corner beads, weep edges, casing beads and expansion joints. Lath accessories such as beads and edges should be nailed or stapled at least every 18 inches. If you are not using self-furring lath, furring strips should be nailed in place after all accessory pieces are in place.

Hanging Metal Lath

Metal lath should be hung horizontally. Joints between panels should be staggered in a standard brick-laying pattern. The seam between the first and second panels on the bottom of the wall should fall in the center of the panel placed immediately above them.

Expanded metal lath has a diamond shaped mesh. In order to form a proper holding base for stucco or plaster, the pockets formed by the mesh should face upward. The mesh should feel rough if you run your hand downward across it and smooth when running your hand upward.

Attach the lath to wood framing with 1-1/2-inch roofing nails. Nails should be 16 inches on center with no more than a six inch vertical spacing. When attaching lath to wood sheathing, 1-1/2 inch staples with a 3/4-inch crown should be used.

Lath should be wire-tied at nine-inch intervals on edge and end laps to prevent separations.

In order to allow the plaster or stucco to properly adhere to the lath, a minimum 1/4-inch gap should be maintained between the lath and the surface of the wall.

Lath can be cut to size and shaped with shears. A standard circular saw with a metal cutting blade can reduce cutting time on a larger job. Always use eye and hearing protection when cutting metal with power tools to prevent serious injury.

References

Promoted By Zergnet

Comments

You May Also Like

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!