How to Remove Congoleum Flooring

Save

Congoleum Corp. produces a wide range of resilient flooring in tile, sheet and plank form. You need to know how to remove the flooring if you want to replace a damaged section with the same Congoleum product. You also need to remove the flooring if you decide to change your flooring type. Taking up an adhered resilient floor takes time and effort to remove both the flooring material and adhesive. Fortunately, Congoleum recommends a removal technique that helps to speed up the floor stripping process.

Things You'll Need

  • Heat gun
  • Utility knife
  • Putty knife
  • Razor-scraper
  • Push broom
  • Wallpaper scraper
  • Wide-bladed floor scraper
  • Respirator
  • Protective gloves
  • Safety glasses

Guide a heat gun along the grout lines of a tile or plank to weaken the jointing material. Cut through the grout with a utility knife to separate neighboring flooring sections.

Direct the heat gun along the side edges of one corner of the isolated flooring section. Work inward from the edges to warm up the corner and soften the underlying adhesive.

Push the blade of a putty knife through the center of the heated corner to gain access to the flooring underside, as recommended by Congoleum. Slide the putty knife in a forward-and-backward motion underneath the flooring and toward the corner edges. Use the putty knife as a lever to push up the corner and lift the flooring from the adhesive.

Position the putty knife under the raised corner and against the still-adhered flooring. Point the heat gun over the stuck flooring, and slide and lift the flooring with the putty knife. Continue with the heat removal technique until you strip all the flooring you want to remove.

Use a razor scraper to remove Congoleum adhesive from the subfloor. Apply a forward-and-backward motion to scrape up the flooring adhesive. Sweep the stripped floor with a push broom to remove the adhesive debris.

Promoted By Zergnet

Comments

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!