How to String a Hay Baler

Save
(Image: Hemera Technologies/Photos.com/Getty Images)

The hay baler is an invention that helps farmers safely and efficiently save hay for winter consumption without the bulk of loose hay. The hay is fed into the baler from a pile on the ground called a windrow. The hay is compressed and tied with a series of hooks and guides by twine, loaded in twine boxes on the baler. Learn to install twine into the hay baler.

Things You'll Need

  • Baler twine
  • Knife

Load six balls of twine in the twine box. The twine box is located under a lift lid on the baler.

Tie the left three balls of twine together. Do the same for the right three balls.

Route the loose end of left-front ball through the guide closest to it, and the loose end of the center ball through the guide closest to it.

Run the twine through the tension plates. The tension plates can be adjusted to increase or decrease the tension of the bale.

From the tension plates, run each line through the guide on the needle yolk. Strands should not not twist or cross at any point.

Pull the two strands through the guide outside the needle yolk next to the ends of the needle.

Separate the two strands and thread them through the guides and through the needle eyes. Tie them off to the chamber brace.

Feed hay into the baler until the chamber is filled and knotters are tripped.

Cut and remove the strands tied off to the chamber brace in Step 7.

Tips & Warnings

  • The first bale will not be tied and will have to be re-baled, but the next one will be tied appropriately.
  • Never operate equipment while installing the twine. Engine of tractor should be off and key removed for safety.

References

Promoted By Zergnet

Comments

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!