Domco Vinyl Floor Installation

Save
Domco offers a choice of vinyl flooring styles to complement your interior design.
Domco offers a choice of vinyl flooring styles to complement your interior design. (Image: Comstock/Comstock/Getty Images)

The Tarkett Group makes the Domco range of vinyl sheet flooring that is billed as one of the longest established brands in the United States. Installing Domco vinyl flooring correctly by following effective subfloor preparation is essential for product longevity, as recommended by the manufacturer. The vinyl flooring is available in a multitude of colors and designs to reflect various wood and stone materials and comes in 12- and 6-foot rolls.

Things You'll Need

  • Drum sander
  • Push broom
  • Water-based degreaser
  • Mop
  • 1/4-inch underlayment-grade plywood
  • Latex-based hydraulic-cementitious patching compound
  • Utility knife
  • Hook-blade knife
  • Tarkett DT-201 vinyl floor adhesive
  • 1/32-by-1/16-by-1/32-inch trowel
  • Three-sectioned 75 lb. manual roller
  • Small hand roller

Remove paint and sealing products from a concrete floor using a drum sander to ensure the vinyl flooring adhesive bonds successfully. Sweep the floor with a push broom to clean up dirt and dust. Use a water-based degreaser to spot clean oily marks from the floor and wipe over the floor with a damp mop.

Install at least 1/4-inch underlayment-grade plywood over a wooden subfloor, as recommended by Tarkett. Remove dust and dirty marks from the plywood underlayment to ensure the Domco flooring adheres effectively. Repair uneven areas of either a concrete or wooden floor with a latex-based hydraulic-cementitious patching compound, as recommended by the vinyl flooring manufacturer.

Acclimatize your Domco flooring and adhesive between 65- and 100-degrees Fahrenheit for at least 48 hours before installation. Take measurements of the floor area and use a utility knife to cut the vinyl flooring to the floor dimensions, allowing an additional 2 inches around the floor perimeter.

Lay out the vinyl flooring in the room and position weighty objects on top to prevent the flooring from sliding out of position. Cut way excess material at inside and outside corners to make the vinyl easier to fit around the floor perimeter. Use a hook-blade knife to cut the vinyl to fit at the bottom of walls, as recommended by the manufacturer.

Pull back the Domco flooring to expose half the sub-floor. Spread Tarkett DT-201 vinyl floor adhesive over the subfloor using a 1/32-by-1/16-by-1/32-inch trowel. Position the vinyl back over the adhesive using a gentle low-angled delivery to prevent air pockets. Bed the flooring into place with a three-sectioned 75 lb. manual roller.

Repeat Step 5 for the other half of the vinyl flooring. Use a small hand roller to bed the Domco flooring into the adhesive around the perimeter edge. Keep the installed flooring at a minimum of 65 degrees Fahrenheit to maintain adhesive performance.

References

Promoted By Zergnet

Comments

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!