Plan the perfect garden with our interactive tool →

How to Disconnect a Lawn Tractor Battery

Removing the battery from a riding mower is as simple as removing the battery from a car. The main reasons to remove the battery are to change or charge it. However, in colder areas it may be necessary to remove the battery when storing it for the winter. In such areas, it is a good practice to remove the battery before the first freeze to ensure the battery will not burst during the winter. No matter the reason, removing the battery is an easy process.

Locate the battery on the mower. Some mowers place the battery under the seat. In others, it is under the hood. If the battery is in another area, check the owner's manual for the proper location.

  • Removing the battery from a riding mower is as simple as removing the battery from a car.
  • However, in colder areas it may be necessary to remove the battery when storing it for the winter.

Remove the positive (red) cable from the battery. Most mower batteries have through-bolted cable ends; thus, you'll use two adjustable wrenches.

Remove the negative (black) cable from the battery terminal. Some mowers have a different-size negative terminal, another reason for the adjustable wrench.

Remove the battery hold-down. Some mowers use a rubber band-type hold-down similar to a bungee cord. Others use a metal hold-down similar to those in a car. Metal hold-downs may require a ratchet and extension to remove.

  • Remove the positive (red) cable from the battery.
  • Remove the negative (black) cable from the battery terminal.

Remove the battery from the tray.

Test A Lawn Tractor Battery

Put the lawn tractor in neutral and push it to an area with a hard surface such as a driveway or garage. The most common areas are under the seat or in the engine compartment. Put on safety glasses to protect your eyes. Fill each battery cell to cover the plates inside with distilled water and press the caps back onto the battery. A sealed battery will not have removable caps. Place an automotive battery charger near the lawn mower. Keep as far away from the battery as possible while clamping the terminals. Clamp the red, positive alligator clip onto the positive battery terminal. Move the battery type selector to 12 volts and the charge rate selector to 10 amps. Read the display on the battery charger to determine how much charge the battery has. If the needle points to 0 amps and the charge percentage is 100, the battery is fully charged.

  • Remove the battery from the tray.
  • Fill each battery cell to cover the plates inside with distilled water and press the caps back onto the battery.

Tip

If storing the battery for the season, store on a piece of cardboard on an elevated warm location. Storing a battery directly on a concrete floor will cause the battery to lose charge over time.

Warning

Do not touch both the positive and negative terminals on the battery at the same time. This will cause a shock.

Related Articles

How to Clean a Toro Snowblower Carb
How to Clean a Toro Snowblower Carb
How to Test a Lawn Mower Battery
How to Test a Lawn Mower Battery
How to Check Compression on a Lawn Mower Engine
How to Check Compression on a Lawn Mower Engine
How to Remove the Engine From a Riding Mower
How to Remove the Engine From a Riding Mower
Cub Cadet LT 1045 Tire Removal
Cub Cadet LT 1045 Tire Removal
How to Diagnose Starter Problems for a John Deere Lawn Tractor
How to Diagnose Starter Problems for a John Deere Lawn...
How to Disassemble a Reel Mower
How to Disassemble a Reel Mower
How to Change the Magneto on a Briggs & Stratton
How to Change the Magneto on a Briggs & Stratton
How to Replace the Pawl on a Husqvarna Chainsaw
How to Replace the Pawl on a Husqvarna Chainsaw
How to Change the Battery in a Cartier Clock
How to Change the Battery in a Cartier Clock
Garden Guides
×