Instructions for Ironing Creases on a Military Uniform Shirt

23530585

Zedcor Wholly Owned/PhotoObjects.net/Getty Images

Nearly every branch of the United States Armed Forces has occasion to wear a shirt with military creases, and the practice is followed also by uniformed police, paramilitary units, and dozens of other groups who aspire to a military appearance. Most professionals in laundry and dry cleaning businesses know how to make military creases, but it can be done less expensively almost anywhere with some experience and proper equipment.

Lay the shirt on the ironing board to look for the locations of the creases. There are five creases in the standard form: three in the back and two in the front. One of the creases in the back is the exact center of the back, and the other two are equidistant from the center to the armholes. In front, the creases march down the front of the shirt in line with the pocket buttons from the shoulder seam to the hem. The sleeves are ironed flat with the crease on the fold on top.

Fill the steam iron with water. After setting it on the ironing board, adjust the temperature to a steam setting appropriate for the fabric of the shirt. l00 percent cotton will take high temperatures; synthetics will require lower temperatures. Set the can of spray starch nearby and have a smooth piece of cotton fabric, such as a piece of an old sheet, nearby also.

Iron the yoke and the collar of the shirt before beginning the creases, if the shirt has a yoke. A yoke is a horizontal piece that forms the top of the back. It extends from shoulder seam to shoulder seam and is not creased with the rest of the back of the shirt. Some military uniforms do not have yokes, and in that case, proceed without this step. Starch and iron the collar, stretching it horizontally, so that it will stand upright during the rest of the ironing.

Pick up the shirt by the back, finding the center of the back by folding the shirt so that the side seams align. This will be the first crease, and it must be absolutely vertical. Press down on this fold, spray it with starch, steam it and iron it dry. If the shirt is white or tends to become shiny, protect it with the cotton cloth, just in case of discoloration from the heat.

Divide the distance between the center crease and the armholes to find the location of the next crease. This can be done by holding the shirt up by the tail and the yoke, making the side seam align with the center crease. Press this fold exactly parallel to the center crease. Follow pressing that crease by doing the same on the other side of the back of the shirt. The back of the shirt is now completely ironed.

Fold the front of the shirt from the seam at the shoulder to the hem directly through the buttonhole on the pocket. Be very sure the fold is vertical. Press the fold as before, using plenty of steam and starch if necessary. Pay special attention to the pocket so that it has no creases or dimples when finished. The second front crease is accomplished the same way. The shirt is now ironed except for the buttons and buttonholes and the sleeves.

Iron the front, pressing hard on the buttonhole area and pressing between the buttons all the way to the edge of the shirt. Iron the sleeves flat, pressing the crease into the top as sharply as the rest of the creases. Touch up any areas that seem unsatisfactory, being careful not to iron over any of the creases.

Iron the pants creases by holding a pantleg by its hem and matching the side seams. The fold in both front and back of the leg should be pressed until it is sharply creased. Proceed to iron the other leg the same way. Finish by pressing both legs flat, seams and creases aligned perfectly.