How to Change the Battery in a Simon Security System

Simon security systems come with a built-in backup battery which should last from four to six hours during a power outage. If you are receiving low battery alarms the battery must be changed. If your system is under warranty check with your dealer, this service may be covered for free. If not, changing the battery is a simple task.

Things You'll Need

  • Phillips screwdriver
  • Regular screwdriver
  • New battery

Video of the Day

Call your monitoring facility and tell them you want to place the unit in “test” for an hour (during test they can still see any alarms but they will not respond to them).

Disconnect the power from your system. The power supply may be secured with a retaining screw; remove it and unplug the system.

Press the tab on the top of the panel and swing the panel down from the base plate, if your unit is wall-mounted use a regular screwdriver to press the tab.

Unplug the connector going from the battery to the system.

Remove the cover from the battery compartment (which is located on the base plate). Note how the wires (red and black) are routed and remove the battery.

Put the new battery in the battery compartment. Replace the cover making sure you tighten the retaining screws fully.

Plug in the new battery. Route the wires through the holes the same way the old battery wires were routed. Swing the panel up and snap it closed.

Plug the unit back in and tighten the power supply retaining screw.

Make sure your system is operational. Call your monitoring facility and have them take the unit off of test.

Tips & Warnings

  • Placing the unit in test mode with your monitoring company allows you to work on the system and to test all of your sensors without setting off an alarm; you should do this monthly according to GE Security. Install the new battery before you plug the unit back in to prevent a low battery alarm. If you have an owner's manual you may not have information about changing the battery. More information is covered in the installation manual which can be downloaded from the GE website (after a rather lengthy registration) or you can download it directly from the Resources section below.

References

Promoted By Zergnet

You May Also Like

M
Is DIY in your DNA? Become part of our maker community.