How to Make a Homemade Skee Ball Game Using Boxes

Save

Making a homemade skee ball game is a fun and interactive way to challenge a child's creative expression. Encourage a child to undertake the activity as an after-school or weekend project. Fitting three to five plastic containers into the top of a medium to large shipping box cardboard container represents the basic design of your skee ball game. Celebrate with your young artists by allowing them to play skee ball, using a ping pong or tennis ball, with friends and family.

Things You'll Need

  • Medium to large shipping box cardboard container
  • Packing tape
  • Large plastic cottage cheese containers (three to five)
  • Marker
  • Utility knife
  • Permanent epoxy
  • 4-by-4-inch copy paper sheets (three to five)
  • 18-by-24-inch shipping box cardboard sheet
  • 3-by-18-inch shipping box cardboard lips (three)
  • Ping pong or tennis ball

Find a medium to large shipping box cardboard container with stable sides. Secure all sides together with packing tape.

Flip the box upside down. Set a large, empty plastic cottage cheese container atop the box at center. Slide the plastic container upwards so it is 1 inch below the top edge. Trace the base of the plastic container with a marker. Continue this process until there is a vertical line of three to five evenly spaced circular outlines.

Cut holes into the box along the trace lines with a utility knife. Set a large, empty and clean plastic cottage cheese container down into each hole. Bond the plastic containers into the holes with permanent epoxy.

Draw the number "10" onto a piece of 4-by-4-inch copy paper. Bond the paper to the outside of the lowest plastic container on the box with permanent epoxy. Write the number "10" into the bottom of the same container. Repeat this process three to five times to create additional scores that increase with every successive container.

Bond one of the 18-inch edges of an 18-by-24-inch shipping box cardboard sheet to the lower edge of the skee ball platform with permanent epoxy. Bond three 3-by-18-inch shipping box cardboard lips together with permanent epoxy. Bond the lip 3 inches below the top edge of the 18-by-24-inch sheet. The sheet and lip act as the panel upon which the ball will roll and skip upwards before falling into one of the containers.

Set the box up against the base of a wall at a 45-degree angle. Adjust the box so the panel is curved outward onto a flat surface. Roll a ping pong or tennis ball up the panel to begin the game.

References

Promoted By Zergnet

Comments

Check It Out

DIY Wood Transfer Christmas Ornaments

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!