Framing concrete steps is neither complicated nor difficult. Once the substrate has been put in place and some fill added over it, all that remains is to frame the steps, pour the concrete and finish it. A few days of curing time and the steps are ready to use for generations. The first step to building the forms is taking measurements and calculating the step rise and tread run.
Calculating Rise and Run
Total rise is the vertical distance from the top landing to the bottom landing. Step rise is the height of each individual step, or riser.
Calculate the number of steps. Most steps have a rise between 6 and 8 inches. 8 inches is fairly high for many people and 6 may seem short, although shorter is better than higher. Begin by dividing the total rise by 7 inches and round the number up to give the number of steps. Example for a total rise of 45 inches: 45 / 7 = 6.43, rounded up = 7. So we will have seven steps.
Next calculate the step rise. Step rise = Total rise / Number of Steps. In our example, this is 45 / 7 = 6.43. So each step will rise 6.43 inches. If that seems low, try only six steps. 45 / 6 = 7.5 inches which is a more reasonable riser height.
Framing Step Forms
Build sturdy forms with 2 x 8 lumber that is ripped to the correct riser height. In our example case, we've decided on six steps, each with a riser height of 7.5 inches, so we will rip our 2 x 8 lumber to a width of 7.5 inches.
The forms are rectangular frames with the inner side open, each form built on top of the previous step. The illustration makes this clear. Use 2 x 4 stakes to hold the forms in place and 3-inch wood screws or double-headed nails for construction. Double-headed nails or screws will make disassembling the forms easy without damaging the fresh concrete.
Add braces to the front of the forms so they won't bulge, as concrete is quite heavy. For each successive step form, brace it with cross pieces nailed or screwed to the step form underneath it.
When building a stoop, add sand as fill to the inside of the forms, but don't overfill. The concrete should be at least four to six inches thick on the sides, the back and between the steps and the fill. Most contractors simply add a mound of sand inside the completed forms, or build the forms around it.
Use a spray can of vegetable oil to lightly coat the inside of the forms before pouring the concrete. This will make form removal easy and quick, while preventing damage to the fresh concrete.
If the steps you are building are against a house, you may need to attach them to the house with rebar. Always check your local building department for code information, permits if necessary, and information on local guidelines before beginning any construction project.
- How to Make Concrete Steps
How to Frame a Concrete Slab
The frame for a concrete slab can literally make or break a building. From the slab placement and alignment of the slab,...
How do I Build Concrete Circular Steps?
Many homeowners are scared to build anything that makes use of concrete. They immediately think that the process would involve heavy construction...
How to Form Curved Concrete Steps
To form curved concrete steps, you need to use a form. Typically, you use wood because you can shape it more easily...