Floor Leveling Techniques


Floors that are not level can feel like an amusement ride as you stroll up and down the high and low points. If your floors are not level and you are considering leveling them, you should know about the tools, materials, and techniques available for a successful floor-leveling project. The average do-it-yourself homeowner can level his or her own floors in 6 to 8 hours, depending on the size of the project.

Tools, Materials, and Methods

  • At least two different methods should be considered for leveling your floors. If your floors are moderately out of level, then you can use floor compound--white powder that is mixed with water and spread out onto the floor to make it level-- to even out those sagging spots. However, if your floors are sagging so much that doors won't close and walls are cracking, then raise the floor from beneath a floor jack and block of wood will do.

    You will need floor leveling compound, a 4 foot level, nylon string,a hand trowel, a 5- gallon bucket, a drill and mixing bucket, and sandpaper for leveling your floors using floor leveling compound.

    You will need nylon string, a 4 foot level, a tape measure, floor jack, 8 inch concrete blocks, short scraps of 2-by-8 block that are at least 16 inches long, a hammer, and wooden wedges for jacking and leveling the floor from beneath.

Leveling Compound

  • Find the low spots in the floor, and stretch a nylon string across those spots; attach the string to the high points of the floor on both sides of the low areas. Use the string as a reference when spreading and smoothing the floor leveler. Make sure that the floor is clean before you begin applying the floor leveler. Add water and leveling powder to a 5-gallon bucket and mix using the drill and mixing bit. Spread the compound until the floor is level with the reference string. Allow the floor to dry and sand away any imperfections with course sandpaper.

Jacking the Floor

  • Raise your floors until they are level using a floor jack. Stretch a nylon string across the floor and attach it at the high points on each side of the floor at the walls. Have a helper stay inside while you go beneath and jack the floor from beneath. Place the floor jack on a supporting beam beneath the floor and jack the floor until it levels above. Place 8 inch blocks on level ground, followed by wooden 2-by-8s, and then wedged.

Related Searches


Promoted By Zergnet


You May Also Like

  • How to Level a Wood Floor

    Leveling the subfloor is a prerequisite for most floor covering installations, including hardwood, laminate and vinyl. Even slight humps and depressions in...

  • How to Use a Self Leveling Floor

    Self-leveling floor compounds provide an easy way to achieve a clean, level floor over old concrete, gypsum or portland sub-floors and some...

  • How to Apply Floor Leveling Compound

    When laying a new floor take care to assure that regardless of the materials used the floor is set in a level...

  • Wood Floor Leveling Techniques

    An uneven wooden floor can be dangerous to walk on and can damage other floor products if it's being used as a...

  • Floor Leveling Materials

    Leveling materials are used to level subfloors before installing carpet or other flooring and to patch floors that have become uneven. Concrete...

  • Concrete Floor Leveling Techniques

    Floor leveling refers to the process of making a floor perfectly even and removing all flaws. This is common when laying wood...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!