Pur Water Filter With Indicator Instructions


The Pur water filter with an electronic indicator is a water purification system for your home. The unit consists of a pitcher with an attached filter. Water is placed in the top of the pitcher and is dispersed through a filter that removes impurities. The electronic indicator lets you know when it's time to change the filter, so you're always drinking clean water.

Before Use

  • Thoroughly clean all parts of the Pur water filter unit prior to use to remove any dust that may have collected when the unit was packaged and shipped. Submerge the filter in a pitcher of water for at least 15 minutes prior to use. While it is soaking, wash the pitcher, pour tray and lid in warm, soapy water and allow them to air dry.

    When the 15 minutes is up, take the filter out of the water and flush it with cold, running water for approximately 10 seconds. You are now ready to put the Pur water filter unit together.

Setup and Use

  • Place the pour tray into the pitcher. Insert the narrow end of the filter into the hole in the middle of the pour tray. Once the filter cannot be pushed down any further, twist it clockwise to lock it into place. The filter is locked when you cannot turn it any further. Be careful not to twist too hard when placing the filter in the pour tray, as you don't want to damage either part of the unit.

    Pour cold water into the pour tray. The water will drain into the pitcher through the filter, which will trap impurities in the water. Be sure to use cold water, as hot water could damage the filter. Wait until the water has fully drained into the pitcher before drinking the water.

Electronic Indicator

  • Place the lid on the pitcher and press the "Reset" button for 5 seconds, or until the light flashes green. The "Reset" button and the indicator light are both found on top of the lid. Every time you pour water from the Pur water filter pitcher, the indicator light will blink. When the light is green, the filter is working fine. If the light turns yellow, then the filter will need to be changed soon. Once the light turns red, you need to replace the filter to ensure proper filtration.

    To change the filter, take the lid off of the pitcher and twist the filter counterclockwise until it can be pulled out of the pour tray. Place a new filter in the pour tray as described above. Reset the indicator light once the lid is placed back on the pitcher.

Related Searches


  • Pur Water Filtration System Owner's Manual; The Procter & Gamble Company
Promoted By Zergnet



You May Also Like

  • How to Replace a Pur Filter

    The quality of the drinking water in most neighborhoods is getting worse and worse. According to most city water agencies, there are...

  • How to Open a Pur Filter

    The Pur Water Filtration System offers a variety of designs for filtering water from your tap at home. To keep your Pur...

  • How to Troubleshoot a Pur Water Filter

    We all need to drink water to live. Many people have filters on their taps to ensure that the water they drink...

  • PUR Filter 4396841 Installation

    You refrigerator has indicated that it's time for a water filter change. You have the Pur 4396841 replacement filter in hand, but...

  • How to Recycle PUR Filters

    Water filters are great for purifying tap water but they all eventually stop working properly at some point. Whether you have to...

  • Features of Pur Water Filters

    Many homeowners are concerned about the safety of their tap water and seek alternate sources when it comes to drinking water. While...

Related Searches

Check It Out

22 DIY Ways to Update Your Home on a Small Budget

Is DIY in your DNA? Become part of our maker community.
Submit Your Work!