- Old grips can be stubborn if they were installed correctly the first time. To remove them, cut a slit in the grip, starting at the end nearest to the clubhead and running all the way up to the end of the shaft. It is then much easier to peel away the unwanted grip and prepare the shaft for the new grip.
- It is not a necessary step to remove the old grip tape from the last grip, but if it is left on, it will thicken the grip somewhat. Also, if the tape is peeling, wrinkled or damaged, it may be a good idea to remove it so that the new grip will adhere firmly. If the end of the tape shows signs of rust, it is a good idea to remove any tape from the end and knock any rust out of the end of the shaft so that loose pieces will not remain in the shaft when the new grip is put on.
- If the thickness of the grip is already set to the desired diameter, one piece of grip tape should be enough. However, if a thicker grip is desired, up to three layers of grip tape can be installed under the new grip. Install each layer individually so that they do not wrinkle, because most wrinkles will be felt after the grip is installed. Solvent should be used liberally and should be poured inside the new grip as well as all along the grip tape. This helps tremendously if the grip is slightly tight.
