How to Program a Dish Network Remote

Save
Next Video:
How to Install a Satellite Dish....5

Programming a Dish Network remote control to a TV involves pressing a combination of commands that allows the TV to read the signal from the remote. Learn how to link up a Dish Network remote control to a television with helpful information from a certified satellite installer in this free video on satellite TV.

Part of the Video Series: Satellite Television Info
Promoted By Zergnet

Comments

Video Transcript

Hi my name is Bill Barney. I'm with Community Dish in Pahrump, Nevada. I'm an SBCA licensed installer, that's Satellite Broadcast Communications Association and I'd like to help you with your satellite installation. We're now going to program the Dish Network remote to control the satellite receiver. The first step in doing that is to come back and on the right side panel you'll find the system info button. With the receiver off you press the system info button. Once that has been pressed the system info screen should come up on the television. Once the system information screen has been brought up you'll notice that there is a green number one and a blue number two. This is the system info screen on a Dish Network dual tuner, that's one receiver that controls two TV's independently. The number one also being coordinated to the number one remote with the green bottom. Next to the number one is the number five. That indicates the remote address that this remote is currently programmed to. It comes default on number one. We're going to change that address by holding the set button down on the upper left hand corner of the remote, press and hold the set button. It's a mode button on the top part of the remote. It's on the left hand side of the remote reading left to right, it's the first button in the line of mode buttons, press and hold it until all the other mode buttons turn red. Once they turn red release the button, the set button will be flashing. Pick a number between one and fourteen. We're going to use the number three, press the number three then pound to lock that code in. Once it has flashed three times, press record three times on your remote, then look at the remote number on the system info screen and make sure that it has changed to the corresponding number on your Dish Network remote and that completes programming the satellite remote to the satellite receiver.

Featured

Related Searches

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!