Ending Off a Square Knot Hemp Bracelet

Video Transcript

"Hi I'm Karen for Expert Village now we'll end our square knot bracelets, untie the carrier lines and just check to see that your about even and then you might want to take it off and check if it fits on your wrist nicely. So that's good, now we're going to end this bracelet with a bead, I pick a black bead to go with our of the colors of the bead we have here and you want to trim off the end so you have straight ends. We're going to put all of these strings into this bead, so I've chosen a bead with a big hole and it does help to rub a little beads wax on that, makes it a little bit easier and just pinch it together and put that bead right on, slide it all the way up to the end of your piece and we're just going to tie a simple knot around and through the loop, make sure you have all of the strands and slide the knot as nice, and if you end up with loose pieces like that you can pull each strand separately until you find the loose one, or wiggle it around until you get all those piece nice and tight and really, really pull it nice and tightly. And cut off never cut it off so close because it's likely to the knot to loosen and eventually come off. So always give it about a quarter of an inch to hang off, has a nice natural look and then that will slip right through your loop like that and your bracelet is finished. That's our square knot bracelet."