Inside Corner Management for Base & Shoe Molding Installation

Video Transcript

" Hi! I am Tim Eaton on behalf of Expert Village and we are working on our inside corner cutting for shoe molding demonstration. So inside corner is very, very easy. There are a couple of different ways to do it, the best and easiest way to do it is just to do 45s, the same way as you did them on an outside corner but they are reversed. Your long end will be the back and the short end will be the front and so you cut your two pieces with 45 and they slide right together in the corner, make a nice tight fit, and little bit of caulking in there and it is good. So this is what the inside corner looks like, just is like this, and we will take a measurement and because this one right here also has an outside corner, so if you come across that make sure that you measure this one out for your outside corner as well like we already demonstrated. So this one is just a simple 45 on the inside corner, it is just as simple as putting your tape on there, and just remembering that whatever measurement get out here is going to be the backside measurement for your outside corner."