How to Finish the Soldering for Circuit Bending

Video Transcript

"AMANDA CLAIRE: All right. So, got the other wire, ready to go. One of them is already soldered into place. I'm going to get the other one there. I'm going to try and use the solder that's already on the board. You can try to use the solder that's already on the board instead of putting new solder there and whoop, there we go. [INDISCERNIBLE] So now we have--so let's kinda review what we've done. We've installed three wires that weren't in the circuit board before. Two of them go to these two little looping points that we kind found through just luck and experimentation. One of them goes to the common point that when were experimenting, we had to connect each of them too then make a looping. We liked that, so we installed the switch in the front, put those wires into position where they would go to the switch and to those points, and so now we'll close it up and test it."