How to Print a Banner

Video Transcript

"Hi everyone, I’m Doug Downey on behalf of Expert Village, I’m here today to show you how to digitally print vinyl banners. Now we have our banner all printed and ready to, to deliver to the customer. So one of the things we have to do, is trim the banner between the two grommets where we started the print off. So what I’ve done here is, I’ve just drawn a quick line between the two grommets, measured it out so that we’re, we’re equal on both sides, and I can just take a pair of scissors and just trim it off. Do a nice quick cut up and cut through the welded, welded edge. And again, like I said earlier if we have a, if we have a full bleed print, you can actually take this here and you can trim that off and again, you can just trim along that line, it will show you that you can leave the grommet in. You still have at least a good three-quarters of an inch of grommet, of welded material that has the grommet in, that’s nice and strong, and they are very low, thin profile grommet, that you can use, that you can screw up anywhere. One of the nice things compared to the older grommets is that the hole is a little bit smaller too, takes small screw-heads now. So you won’t have to get some great big washers to secure it to a fence or a building or something like that. "