How to apply - Bio-stimulants, beneficial bacteria, fungi and mycorrhizal products directly to the root zone for healthy, long lasting trees and shrubs.

Introduction

Biological soil amendments can transform virtually any soil into a fertile forest floor! Professionals have been using Rhizofuel for years... now homeowners can take advantage of this great product.

By: kpottmeyer

Length: 0:00

Comments: 0

View more articles by this author

Flag | RSS

(0)

Add to Favorites

URL:
Embed:

Instructions

Text Size: – +

Print Article

Difficulty: Moderately Easy

Tips & Warnings:

Important:
Do not over water your plants:
Use only enough water to dampen the soil all around the plant.
Spread the water and Rhizofuel throughout the root zone:
Do not put all of it in one spot.
Use all of the solution in one session:
Water activates the microorganisms immediately.
Follow G-12 cleaning instructions after each use.

Step1

Grocor G-12 Liquid Feeder Unscrew G-12 Liquid Feeder top to remove it from the bottle.
Add 1 tablespoon of Rhizofuel to the feeder bottle.
Add 36 oz of water and stir until completely dissolved – do not shake.

Step2

You must insert the straw in the bottom of the G-12 Feeder top.
Replace the top onto the bottle.
Turn dial to the #5 Setting

Step3

Make first insertion 3 feet from the trunk. Moving around the tree, make consecutive insertions 2 ½ to 3 feet apart. Once you have completed your first circle around the tree, increase your distance from the trunk an additional 3’. Again, continue moving around the tree making consecutive insertions 2 ½ to 3 feet apart.

Step4

Continue insertions in circles around the tree until you are approximately 12” beyond the drip line (straight down from outmost edge of the tree). Each injection should last no more than 15 seconds before moving to the next insertion point.

Step5

For smaller plants (shrubs, roses, flowers, and perennials):
Make 2-4 insertions around the drip line (straight down from outmost edge of the plant). Each injection should last no more than 15-20 seconds before moving to the next insertion point.