Comments on: How to Program a Zenith Universal Remote Control

on 11/17/2008 I need help I have a DAEWOO tv and a zenith remote and have tried the instruction for locating the code and it was 019 and it did not work I also have 8 other codes and no lunk and ideas would help. Thanks

on 1/9/2008 I have a small zenith remote with no code search button; I have programmed it before but now I cannot figure it out. Any ideas

on 10/30/2007 Zenit Remote Control Codes from Zenith Universal Manual:
http://www.tritronicsinc.com/remote_controls/downloads/zen100-725.pdf

on 10/27/2006 I have a toshiba television, and a zenith remote...but everywhere on the web has the same codes, but they dont' work....I press and hold the code search button, till the LED stays on, then I press the TV button, then I enter the code. There are only four codes available, and when I enter them, only two of them make the LED flash, but none of them work. This is really pissin me off, and its driving me crazy....someone please help. My email is bdsurace@gmail.com

on 4/3/2006 To identify what code number is currently programmed in your remote:

1. Hold Code Search button 3 seconds until it stays lit.
2. Press mode button (VCR, TV, etc)
3. Press but don't hold Code Search button.
4. Find the first digit: press the number keys in order (1,2,3,4...) until indicator light flashes. The last number pressed is the first digit - write it down.
5. Again press the number keys in order until light flashes for the second digit. Repeat this again for the third digit.

on 6/11/2007 The Zenith manual lists Orion as code 105, but it turned out to be 115 to
get my Orion 1324 to work. I had to try the code search technique several times before finding it by using channel up instead of the power button.

on 11/22/2005 Hold down the code search button until LED lights up, then continuously hit the channel up button until the channel changes. If you flip past the channel hit the channel down button and then hit mute and it should work.

on 11/22/2005 After you do the code search, hit the mute button to turn off the LED light and it will begin working.

on 6/11/2007 You must press the M (mute) key in order to save your code for the Zenith 425. You can find the complete instruction manual at:

http://www.tritronicsinc.com/zenith_remote_controls.html

on 6/11/2007 Go to http://www.zenithservice.com and download your manual. I did.

on 6/11/2007 1. Manually turn on the device you wish to program.
2. Press and hold the CODE SEARCH button until the indicator light turns on and stays on. Release the CODE SEARCH button.
3. Press the appropriate device button (TV, VCR, CABLE, DVD, or AUX) The indicator light will blink again and remain on.
4. Press the POWER button repeatedly until the device shuts off. This may take up to 300 tries, so don't go too fast or you might skip over the one you need. If you do skip over a code, press the CHANNEL DOWN button to back up.
5. Press the MUTE button to complete setup.

on 1/9/2008 After using the code search feature, you must press the enter key for the LED to go out and save your setting.

on 11/22/2005 Code Search-Press code search and hold for led. Press feature button and hit the off button repeatedly until the device goes off. (Start with the device on!) May have to press many times! It works!