Reflective Tape Requirements

Save

Reflective tape is required for large commercial vehicles such as trucks or personal vehicles that are sometimes used for commercial purposes. There are laws and guidelines for where reflective tape should be placed so that other cars on the road can spot them more easily when driving at night.

Colors

  • The proper colors of reflective tape for trucks and tractor trailers are red and white, as this is what will optimally pick up and reflect the light from approaching headlights at night. Usually 6 inches of each strip of tape is red and 6 inches of the other half is white. These colors switch off intermittently as the tape is unspooled and have varying degrees of reflection power, based upon the quality of the reflective tape.

Placement on Flatbeds

  • Reflective tape should be placed in specific areas on flatbeds and be visible when they are empty or carrying a box trailer for transport. The tape should be attached along the lower edge of the box trailer, so that it is visible at night from all angles where an approaching vehicle with headlights would be able to see it. The reflective tape should also be attached to the metal hitch on the back of the flatbed, so that vehicles approaching from behind will see two strips of reflective tape, drawing more attention to the presence of the truck.

Placement on Tankers

  • Large tanker trucks carrying liquids, ranging from milk to gasoline, must also have reflective tape on the truck itself, though in different places and patterns then regular flatbeds or box trailers. While reflective tape should be attached to the back base of the tanker and the metal hitch near the rear wheels, there is no place to put reflective tank on the sides except on the tanker itself. Therefore, strips of reflective tape should be intermittently placed in a straight line along the middle of the tanker's body, so that headlights illuminating the tanker from the side will see numerous dashes of reflective tape, as opposed to one long one. This will help approaching vehicles to recognize it is a tanker truck.

References

Promoted By Zergnet

Comments

You May Also Like

  • How to Install Heat Tape on a Mobile Home

    Most mobile home water pipes connect to the water service under the home where air is cold and damp. If these pipes...

  • How to Remove Reflective Tape

    Reflective tape is stronger and more durable than regular vinyl tape. Reflective tape is designed for outdoor, heavy-duty uses. This kind of...

  • Semitrailer Lighting Regulations

    Every vehicle that you can drive on a public road has specific equipment regulations. Proper lighting is one of these regulations, as...

  • DOT Tape Requirements

    In December of 1992, the National Highway Traffic Safety Administration, which regulates the Department of Transportation (DOT), published a new federal law...

  • Proper Way to Mark a Semi Truck

    Before you can place a semi truck into operation as a commercial motor vehicle, you have to mark it with lettering that...

Related Searches

Check It Out

How To Travel For Free With Reward Points

M
Is DIY in your DNA? Become part of our maker community.
Submit Your Work!